GA-H61M-DS2 1155 CPU socket first time test removal, with a help of hot plate and hot air gun. BGA

[@darrenmurphy6251]

I cringe at people saying they "fix" bent socket pins ,i would never trust that mobo not to short out my cpu one day as the pins snap after a cpu refit ,so i respect your attempt at socket replacement

[@jonnotuckster8856]

I repaired some pins on a z170 a mobo that now runs an i9 9900k yes a 6th gen mobo with 9th gen cpu (modded bios)

[@sydskits5962]

I had a similar incident where pins on 1155 socket broke and shorted the cpu, dead cpu dead gpu dead VRM the ram somehow survived? I took the board to a repairmen and he dismounted the heatsink rotates the board 180 and a few pins fell on his desk he looks at me with a confused look I never forget that. The pc never moved from the place it was located at these boards with this socket design is just a bad design to much pressure the board bends loose contact ram issues, no boot etc. Corrosion on pins within a year if you live in humid climate.

[@SidneyCritic]

After seeing that, I'm not doing mine - lol -. I'm going to try the flux, oven, and bump when solder is molten, shortcut method.

[@maciejukasik1828]

If you want to put it into the kitchen oven then bear in mind that in order to liquidify solder you will have to expose whole board with all elements for a prolonged time to rather high temperature the possible consequences would be: bad capacitors and detaching falling elements. I wolud propose you to refrain from it, buy simple hot air and temperature meter. If you have no hot plate use inverted iron beneath board. I think even preheating board in oven is not a good idea since it might kill caps too. I have posted another video concerning the subject: kzbin.info/www/bejne/rZm5lYmtl61sfJo

[@estebanblascotrasobares8755]

Which hot-plate did you use?

[@maciejukasik1828]

DIY mount for "Bottom heating plate 180х180mm 800W for BGA repair station" with a temperature regulation

[@estebanblascotrasobares8755]

@@maciejukasik1828 Thanks.

[@jonnotuckster8856]

I did this with a home made station taking it off is easy enough putting it back on is the hard part I panicked when the socket started to melt when putting it back on so I tried to pull it back off and ripped a few pads off ffs There’s a video on my page of my removal part but I never put the replacement attempt on here as it wasn’t good lol

[@maciejukasik1828]

kzbin.info/www/bejne/rZm5lYmtl61sfJo

[@AM52-y8f]

На какой температуре фен?

[@maciejukasik1828]

это в описании 360 degC