The video shows an incorrect installation of the oil filter. The correct order of the filter installation is shown here -> kzbin.info/www/bejne/m2LQlo2clJaNb5I
@JonathanFunkhouseMonkhouse2 жыл бұрын
Watched this as I’m going to change oil on my CX for the first time this week (I haven’t had it long). Thought it didn’t look right and that spring would push the filter away from sealing it. Thanks to the other comments, I’ll put my bike back together properly.
@phucthienvo2240Ай бұрын
❤❤❤❤❤❤❤❤❤❤❤❤❤❤
@manfredsawatzki5636Ай бұрын
Ferde Scheibe dann der filter
@ganwarАй бұрын
Zgadza się, tu jest pokazane jak powinno być - kzbin.info/www/bejne/m2LQlo2clJaNb5I
@rock87garage Жыл бұрын
Дякую)
@manfredsawatzki5636Ай бұрын
Der ölfilter ist falsch rum drin
@ganwarАй бұрын
Zgadza się, tu jest pokazane jak powinno być - kzbin.info/www/bejne/m2LQlo2clJaNb5I
@Gast-0122 жыл бұрын
Вчера купил Honda Silver ving 500 1983 года 18000 км
@grigorismoraitis92992 жыл бұрын
Your refill was about 3 liters of oil?
@ganwar2 жыл бұрын
According to the service manual, the capacity of the oil system is 3 liters, with an oil change of 2.5 liters. I poured about 2.2 liters during my replacement.
@manfredsawatzki5636Ай бұрын
Der Filter ist falsch zusmen gesteckt
@павелстарицкий-л8ф3 жыл бұрын
Хочется услышать работу двигателя
@ganwar3 жыл бұрын
Посмотрите мое видео по ремонту глушителей.
@gravesclayton36043 жыл бұрын
NIEPRAWIDŁOWO ZAMONTOWAŁEŚ FILTR OLEJU W GL500 I NIE BĘDZIE PRZEPŁYWAĆ OLEJU PRZEZ TWÓJ FILTR, TYLKO FILTR MOKRY! ZŁOŻYCIE TO RAZEM DO TYŁU!! PRAWIDŁOWA KOLEJNOŚĆ MONTAŻU TO: ŚRUBA - SPRĘŻYNA - PODKŁADKA - FILTR!
@ganwar3 жыл бұрын
That's right, I checked the viewer's vigilance. It took a long time for someone to notice that the assembly was incorrect. The correct installation of the oil filter is shown here. -> kzbin.info/www/bejne/m2LQlo2clJaNb5I
@carlosgooglemaps943 жыл бұрын
Besides the wrong procedure of re-fitting the whole assembly something must be wrong with it, shouldn’t be that hard to remove the center bolt and also you didn’t inspect the o-rings (one for the bolt and the big one for the cover) for one dollar fifty more or les I always put new ones at every oil change, so your careless “tutorial” is not good
@ganwar3 жыл бұрын
O-rings are good, no leaks. The correct procedure for installing the filter is on another film, it is also marked in the first comment of this film. Thanks for your comments. Best regards.
@carlosgooglemaps943 жыл бұрын
@@ganwar ok, I saw the video but hey couple of o-rings don’t cost much and the old ones are cooked and flat leaking or not, regards to you too mate!👍🏻