GE Dryer Repair - Noisy While Running - Top Bearing Assembly

[@craigdehoog5189]

My daughter and I tackled this project with your video as our guide! It worked! The glides or bushings were GONE!!. 😮 The new one is much quieter. I think it was $90 for parts. Got parts from Appliance Part Pros, I couldn’t tell on eBay if I was getting the right one. Thanks!🎉

[@mswatchman4u]

did glides come with your front bearing part or did you have to order them separately?

[@chrisperedney8999]

Great step by step, including putting it back together

[@marsh7695]

your video was great! only one i could find on this dryer. Im trying to change my belt.

[@waltmiller2363]

Did you find a video specific to the belt? That's where I am now until I took it apart and realized the upper bearing is worn down!

[@searaypi_SME]

Your video and explanation were good and very thorough.

[@mrtodd3620]

I'll tell you a way that is a lot easier: Remove 2 screws on front near lint screen. Raise lower bearing on each end, press upper bearing into place. Return lower bearing to place and secure with screws.

[@manny9644]

Do as @ mrtodd says. 2 screws and a few much easier clips and the bottom panel comes off. Then its a breeze. Top first, followed by the bottom. I had actually realized i bent a little of the metal on the top portion trying to force it in. But easily straightened out with some smooth plier action.

[@sherrya6902]

How do you separate that water line attached to the door. You didn’t show and I can’t get mine apart..

[@craigdehoog5189]

Press the end to the middle as you pull the tube out. To put it back in just press it in.

[@sherrya6902]

Also…what is that piece of material sticking down?

[@dtreviews]

Why not show how to disconnect the water line?

[@Elpipiton]

Way to cover the most important step haha. Thanks tho 👍