Generate Sinusoidal PWM using TMS320F28379D example files from TI

[@yaminipoornathilaka]

Hi.... It was very wonderful session... Please upload more videos on programs... !

[@LeticiaAAdase]

THANKS FOR SHARING

[@sadumunisekhar94]

Nice vedio sir

[@premkbhanabhagvanwala1784]

Sir I finally done coding as you. I just wanted to know why we use both same value of compAValue? So is there any need to define compBValue?

[@ramkrishanmaheshwari5702]

No, In this code, you dont need two different value for compAValue and compBvalue. You may need it for some other case depending on application.

[@TrimurtiGrocery]

Sir, Is this code for a single phase inverter or three phase??

[@TrimurtiGrocery]

Please 🙏🙏 give me the answer

[@confusedhumanbeings6372]

like in my simulation i took a carrier of 25KHz. so here, i will generate F_pwm of 25kHz na ???? so then what should the TBPRD will be taken in the code . that will be decided after selecting TBCLK na????

[@premkbhanabhagvanwala1784]

Sir as you Write del_theta=((0*ffff)*Freq*2*epwm1_timer_tbprd*(1/10^6)); In this equation which parameter is changing in one sample period? Because value of REFA_H depends on theta and theta depends on del_theta. So del_theta must be vary in order to vary REFA_H. can you please clear my doubts?

[@chagamureddyvenkatasubbare8051]

Hello Sir... Maximum how many ADCs can we use simultaneously in this launchpad. Actually my application needed 5 ADCs.

[@shubendra11]

Hello Sir, I have a query regarding Vm (Modulation Index). The value of 1000 that was initialized corresponds to a modulation index of 1 or am I interpreting it wrong?

[@ramkrishanmaheshwari5702]

yes...mod.index 1 corresponds to 1000 in this example

[@shubendra11]

@@ramkrishanmaheshwari5702 So if I were to initialize an ADC pin which would vary the modulation index from say 0.05 to 1 that would be work fine.

[@chagamureddyvenkatasubbare8051]

sir. how to choose TBCLK or FCLK

[@confusedhumanbeings6372]

sir, can you tell how to select T_TBCLK if i dont know the TBPRD value but i know T_pwm.

[@mahmoudkhames6455]

Could you help me how can I use eQEP block for encoder?

[@think7677]

You can provide full code. For understanding.

[@salahalatai8255]

THIS CONTROLLER CAN GENERATE MULTILEVEL PULSES? could I get the code pls ?

[@santhoshbh5895]

Sir i am trying to program flash memory in TMS320F280049C...... Code is running but after reset getting erased, can you pls give your comments.

[@uzidesigns23]

sir, can you please share this code?

[@AmitKumar-xv9lq]

Hello Sir, I am using the F28379D to generate the PWM pulses for my hardware system. I have generated PWM pulses in open loop. Sir, Can you upload one video related to close loop. Thank you sir...

[@hoathai7657]

Hello Sir, I doing project same you and It is difficult to control my system. Can you share knowledge PWM close loop? Thanks.

[@sravanslv5191]

can u share the code once

[@madres8580]

THIS CONTROLLER CAN GENERATE MULTILEVEL PULSES

[@salahalatai8255]

could I get the code please

[@pratikrahate8667]

very low voice when you switch to ccs