Get started with PSIM code generation using F28379D

[@huleadan]

code generation for F28379D is great! will this be implemented in PSIM12?

[@altairhowto]

yes, will be available with v12 release

[@ArgentavisMagnificens]

Great video! I'm having one issue though: when I open the component library, only the PWM X-BAR and Output X-BAR blocks appear (under F2837x target), and I can't seem to find them anywhere, although these blocks are being used in the examples. They show up normally for the other processors though. I'm using PSIM 12.0.1 by the way. I would very much appreciate any help I could get. Thanks in advance

[@altairhowto]

if you don't have the module you won't see the elements... are you looking in simcoder->F2837x Target? You can check if the module is enabled if you go to help->about PSIM. For university research licenses with the code generation package we have not finished updating everyone's license yet, this will take a couple of days.

[@ArgentavisMagnificens]

@@altairhowto that was exactly the issue, thanks for the quick response!

[@professorhenriquemarin7728]

@@altairhowto I have an educational license of PSIM 12.0.3. Do you know if SimCoder is available in this case? I couldn't see the elements of SimCoder yet

[@altairhowto]

@@professorhenriquemarin7728 at what Univ are you, Universidade Tecnologica Federal do Parana? If you go to PSIM menu Help> About PSIM and copy/paste the license number we can confirm the license you are using and what is available.

[@professorhenriquemarin7728]

@@altairhowto The License number is: Softkey 1353996284 - 12.0 I am in Estácio de Sá University.

[@kumarutkarshut1]

Hi! How to change duty cycle from ccs?

[@artemgribanov493]

Hello. What is the limited PSIM demo version of the program?

[@altairhowto]

what about it? it has a component limit and simulation length limit and can be downloaded from our website www.powersimtech.com

[@iliashussain5162]

Some error is generated in ccs as XDIAS not installed.i m using ccs v8 .what to do

[@altairhowto]

You will find a tutorial video on the subject if you look a bit harder on our channel