Gep RC SMART 35 Dual Stack Custom Build

In this video, we take a look at scratch building a GepRC Smart 35 using the dual 20 x 20 mounting holes. This allows us to have front and rear 20 x 20 stacks.

[@MinusTacosTheOriginalBroTaco]

super clean! ive had a very similar idea for the tinyhawk 2 freestyle, only using 16x16 stack in the front and a nano vtx and nano elrs module stack in the back, all on some sort of custom mounting plate for the tinyhawk's special mounting holes. havent dont it yet 'cause a 16x16 stack is like $65 right now lol

[@crash_lander]

I have a 20x20 mamba stack. The FC has MPU6000, hard to come by these days, it’s also packed with features. Instead of going for another FC of a smaller foot print I’d rather file the stand off about a millimeter deep ensuring it doesn’t touch and get some heat shrink over the filed notch, just in case. What do you think about this idea sir?

[@MicronWings]

Sanding 1mm may be okay but whenever you start sanding FC boards there's always a risk you could damage it.

[@crash_lander]

I’d never do that. What I want to do is, file a notch in the aluminum stand-off exactly where the FC board is touching my.

[@cubefpv]

@@crash_lander Oh okay then that sounds fine. Should work as long as there is clearance.

[@crash_lander]

Hello Cube. I finished building my Smart35 with 20x20 F722 40A Mamba stack. 1404 3750KV motors on 450mah 4s. It came out amazingly well, but I’m unable to get a good tune on it with BF 4.3. Any help will be appreciated.

[@cubefpv]

@@crash_lander You can take a look at this page on my website - cubefpv.com/blheli32-setup-main-page/ This is my standard setup for BL32. Thisis a good place to start. But it doesn't go into tuning. If you want to get into tuning you will need to look for a detailed tuning guide. Check out Chris Rosser's channel for a BF tuning guide.

[@elsonalbao4824]

Will this frame fit a nebula pro camera?

[@cubefpv]

Yes the frame is designed for any 19mm camera.

[@elsonalbao4824]

I see, so if thats the case how did it fit the smaller nebula pro nano camera?

[@cubefpv]

@@elsonalbao4824 If you are fitting a 14mm camera you will ned to use spacers between the camera and the side plates as well as longer screws.