A 2 Hour job was turning into a 8 Hr job.. Your fix made the job make money.. Thanks !!.
@sheild11178 ай бұрын
I would’ve never thought a video had to be made about a stubborn c clip.
@isaach20003 ай бұрын
I just wanted to say THANK YOU! I’ve been struggling to take this C clamp off for a while and i came across your video. Thank you 🙏
@tatt2d7695 күн бұрын
2hrs later all I can say is Thank You!!!
@Personalized_WorkshopАй бұрын
Holy Crud!! I so hope this works for me in the morning. That you for sharing this.
@davericklee6567Ай бұрын
Dammit you a genius for this 😂😂😂
@y0riai. Жыл бұрын
Mate, it worked like magic. Thanks amigo.
@alphadog19615 ай бұрын
BINGO,just what I needed,THANKS Buddy.
@kcroc448 ай бұрын
This video was really helpful thank you brother !!!!
@PRE_7.34 ай бұрын
Bro …. So slick. So simple. CLUTCH homie.
@ultimateneeb998 ай бұрын
Thank you!! I was stuck on this step and the clamp made it so easy. I assume it needed to overcome the oil seal.
@jagisss10 ай бұрын
Great stuff! Thanks
@kimseymour889618 күн бұрын
That’s a sweet move
@maxolson620410 ай бұрын
Genius
@yamahaguy17328 ай бұрын
Thank you so much!
@user-or6mh8rz1c8 ай бұрын
Thank you!
@gunnerwilliams62299 ай бұрын
Great man
@littleredtractor11267 ай бұрын
Tat helped alot! Thanks. Any suggestions as I still can't pull my right rear axle out, even though I now have the C clip removed
@kcroc448 ай бұрын
Any tips for a stuck repair bearing, slide hammer isn’t making it budge
@stuartwood26777 ай бұрын
Sorry for the late reply. You've probably figured it out already but if I'm replacing bearings then I don't care if I just break them out, just try not to damage the reluctor behind the bearing. The bearings are on there super tight. A lot of penetrating oil and just smashing the crap out of it with a slide hammer. Try a heavier duty slide hammer.
@mobiletech88262 ай бұрын
Hi, can I keep the vehicle in park once it's lined up to remove pin & C Clip plus axle?
@IKnowAGuyLLC9 күн бұрын
The axles still won’t slide out, after clip is removed. Ugh
@orionmythАй бұрын
I replace the bearing and seal about 3 or 4 months ago and there was no trouble at all now it's leaking again and I can't get the axle to push in for the c-clip to pop out
@DirtprosАй бұрын
Same with me. I'm missing half the width of the clip. Thinking of shaving it down with a small airgrinder to make it thinner....
@orionmythАй бұрын
@@Dirtpros exactly I have considered doing that or drilling a small hole to break the tips off once the clip and axle is out we will definitely find some obstruction in there
@robertfarnham36525 ай бұрын
I can get the quest out without putting a c-clamp or anything on to it it's not that hard to get that c-clip out
@BigDmax045 ай бұрын
Can these cause side to side play if they are worn out?