THANK YOU SO MUCH FOR THIS VIDEO!! helped me keep my 2011 GMC going. I didn't realize this car had so many engine issues when i bought it.
@professorlugnut2 жыл бұрын
Glad it helped!
@moondancer334Ай бұрын
I have a 2011 Terrain V6 3.0L DOHC, only 42,000 miles but was just investigating at what mileage I need to have the timing chain replaced, wasn't even sure if it had a belt or chain. How many miles is the chain supposed to be replaced at? Thanks so much for this video.
@professorlugnutАй бұрын
Mileage isn't the big issue. Most of the time it is maintenance, oil changes and all.
@moondancer334Ай бұрын
@@professorlugnut Thanks. so if that's the case, how does one know when it needs to be replaced? what are the signs to look for?
@professorlugnutАй бұрын
@@moondancer334Usually they either make noise rattle etc. I've seen factory chains go bad as early as 30k miles and also seen them last 200k.
@alhavana9426 Жыл бұрын
good video I hve a 2013 gmc terrain with 2.4 4cyl ecotec question about the Ecotec timing chain install When I first start up the car It sounds like a boat motor but then goes away in about five seconds I'm pretty sure it's a stretch timing chain or bad guides,some videos show the timing marks and all that but do you have to put the engine in top dead center before you even install the timing chains and balancers and all that
@professorlugnut Жыл бұрын
Before you remove the chains make sure all the marks are in the locations in the video. it will be at top dead center on cylinder 1.
@JG35420 Жыл бұрын
Could crankshaft and camshaft correlation codes be caused by a faulty timing chain or components
@professorlugnut Жыл бұрын
Yes a stretched chain could cause those codes or the phasers stuck, where the computer doesn't know exactly where they are.
@Wolf-wf6yx2 жыл бұрын
Sweet
@TRY81GETYOU2 жыл бұрын
hello my brother plz can you tell the problam why did you change it ? because i have some problems and my has really bad noise from Terrain Timing and its has stop the car 2 times ????
@professorlugnut2 жыл бұрын
timing chain was rattling and throwing codes.
@codybrannan8225 Жыл бұрын
@Proflugnut 1 will you post the link where you got the parts please sir
@diontaperkins5193 Жыл бұрын
Do you have have cylinder heads resurfaced when timing chain jumped ?
@professorlugnut Жыл бұрын
If chains jump it probably will have bent valves, and broken rocker arms.