GMRS - Coax Matters!!! What to use & what not to use!

  Рет қаралды 5,179

MedinaCountyTexasGMRS

MedinaCountyTexasGMRS

Күн бұрын

Take a look at a few different coax cables that are available for you to buy. The rule of thumb is DON'T SKIMP ON THE COAX!!! Spend the extra cash and get a good solid coax for your system. Amazon Chinese crap will cause line loss and the outer jacket will not hold up to the elements.

Пікірлер: 30
@goodoz9942
@goodoz9942 2 жыл бұрын
I recently purchased a 60Ft jumper for my 50W radio...and I need every bit of it...it's a perfect length for my base/radio to antenna scenario. LMR600. Without mentioning the technical stuff, I now have 38.7W of RF power at the antenna (that's 122W of ERP w/5db gain antenna). If you use your radios, good cable is worth every penny spent!
@MCTGMRS78009
@MCTGMRS78009 2 жыл бұрын
That's great output for 60 feet! Thanks for commenting!
@arconeagain
@arconeagain Жыл бұрын
That's right, and most don't consider the ERP. I made a phasing harness for a pair of 6 element yagis for a local here. He bought this cheap RG213, and he'd spent around $20,000 (Australian) on his entire setup! The 213 was so bad and he was going to replace it with mil spec. I said spend a little extra on half inch Heliax, why let the entire system down, utilise the maximum potential of that investment. Now with over 11DBD of gain and about a kilowatt, the ERP figure goes through the roof, even compared to 213 or LMR400. Don't forget it works both ways too, on receive. The proof is you Americans on 38 LSB would very likely hear this guy on a daily basis, 176 Trevor, Central Victoria, Australia.
@JohnGEmery
@JohnGEmery 11 күн бұрын
Hello ' this is John ,WSEJ563" Question what would be a good coax to use for a GMRS Midland 400TX that I'm using for a base
@MCTGMRS78009
@MCTGMRS78009 10 күн бұрын
Midland sells a really good grade coax on their website or Amazon and I have yet to ever have issues with it. It comes with an attached mag mount and the 259 connector is actually an adapter with can be removed for easy pass-through when running the cable.
@BorisEkner
@BorisEkner Жыл бұрын
Messi & Paoloni is probably the best coax we can buy today.
@MCTGMRS78009
@MCTGMRS78009 Жыл бұрын
Heliax is some tough stuff and gives awesome results... I will look into Messi & Paoloni on my next project. 👍
@jonsimmons5041
@jonsimmons5041 5 ай бұрын
What about OHMS ?
@MCTGMRS78009
@MCTGMRS78009 5 ай бұрын
We'll leave that for the "smarter" guys. Coax is truly one of those things that you get what you pay for. Thoughts???
@jdsmith52565
@jdsmith52565 5 ай бұрын
Disappointed--I was waiting to see what coffee brand you were sipping. lol. No, seriously, great video! :) I have 50ft RG8X that I bought for CB a few months ago and maybe gonna try it. Just surfing around seeing what people were using for GMRS base.
@MCTGMRS78009
@MCTGMRS78009 5 ай бұрын
🤣🤣🤣 much appreciated! Thanks for watching! And btw.. its the Walmart brand kurig pods 😒
@MRxMADHATTER
@MRxMADHATTER 3 ай бұрын
If it's crap, why did you buy it?
@MCTGMRS78009
@MCTGMRS78009 3 ай бұрын
Just to try it and compare... thanks for asking.
@MRxMADHATTER
@MRxMADHATTER 3 ай бұрын
@@MCTGMRS78009 if you want your camera to focus you need to get anything with writing on it out of the frame.. Your coffee mug is getting the preferential treatment for focus because it has words on it.
@MCTGMRS78009
@MCTGMRS78009 2 ай бұрын
I won't be moving my coffee cup. THANKS for the suggestion tho!
@joestreiff9401
@joestreiff9401 10 ай бұрын
if its not "times microwave", it's a crap shoot
@georger987
@georger987 5 ай бұрын
Q: Midland uses that good coax connectors. NOT the NMO mount. IF I want to shorten the cable length, where can I buy those RG-58 connectors? I want to crimp the termination. I do not want to solder.
@MCTGMRS78009
@MCTGMRS78009 5 ай бұрын
I ordered some on Amazon that allow you crimp it but the center conductor has to be soldered
@georger987
@georger987 5 ай бұрын
@@MCTGMRS78009 OK.... Thanks again.
@ricruso59
@ricruso59 6 ай бұрын
Nice! Thanks man!!!
@MCTGMRS78009
@MCTGMRS78009 6 ай бұрын
Anytime! Thanks for watching!
@rozd618
@rozd618 Жыл бұрын
Are you familiar with the coax midland uses for the gmrs whip antennas? Is that the same stuff you un bagged or is it junk? I'm planning to order the coat antenna and the 32 inch whip with the NMO mounts.
@MCTGMRS78009
@MCTGMRS78009 Жыл бұрын
Their coax seems to be VERY durable and holds up well. A lot of the guys in the club have used it as well with no complaints.
@boonetompkins161
@boonetompkins161 Жыл бұрын
Thanks for the video!!!!
@MCTGMRS78009
@MCTGMRS78009 Жыл бұрын
Your absolutely welcome... figured folks should see how poorly the cheap Amazon stuff is.
@virginiavirginia477
@virginiavirginia477 2 жыл бұрын
Nice info. Thank you. Also.. is that Keto coffee?
@MCTGMRS
@MCTGMRS 2 жыл бұрын
That cup was not BUT a few cups before it was. Lol. Thanks for taking time to comment 😊.
@HarryHamsterChannel
@HarryHamsterChannel Жыл бұрын
How much loss? What are your test results?
@MCTGMRS78009
@MCTGMRS78009 Жыл бұрын
Here we go 🤣
Does Power Really Matter On GMRS & Ham Radio, Or Is A Good Antenna Better?
10:52
NotaRubicon Productions
Рет қаралды 55 М.
The most deadly project on the Internet
15:14
bigclivedotcom
Рет қаралды 7 МЛН
Стойкость Фёдора поразила всех!
00:58
МИНУС БАЛЛ
Рет қаралды 4,5 МЛН
Brawl Stars Edit😈📕
00:15
Kan Andrey
Рет қаралды 58 МЛН
How To Get Married:   #short
00:22
Jin and Hattie
Рет қаралды 23 МЛН
I Bought KMR-400 Coax From Amazon | How Bad Can It Be?
9:01
Ham Radio Tube
Рет қаралды 80 М.
GMRS Base radio, what do you need?
22:40
Thomas-ZET
Рет қаралды 2,3 М.
Building a GMRS J Pole out of 14 gauge house wire.
27:53
Rick's Shop
Рет қаралды 66 М.
What to do with Excess Cable? (#656)
13:14
David Casler Ask Dave
Рет қаралды 20 М.
Ask Michael, KB9VBR: What's the Best GMRS antenna for hilly areas
6:45
Стойкость Фёдора поразила всех!
00:58
МИНУС БАЛЛ
Рет қаралды 4,5 МЛН