GOLF CART PROBLEM ? Not running , surging , runs intermittently ? How to fix it yourself

  Рет қаралды 2,452

FIX IT YOURSELF

FIX IT YOURSELF

Күн бұрын

Пікірлер: 7
@daverhaci6369
@daverhaci6369 18 күн бұрын
Hi, Great Video! Apparently my G29’s Motor is stuck on the transaxle. Do you think I can do this service while the motor is still on the transaxle? I am sure the springs on the brushes would be the biggest headache if I try to do it without removing it. Also any tips on removing the stuck motor from the transaxle?
@backshed5295
@backshed5295 18 күн бұрын
no mate you cannot do it any other way, i have done 100s and never had 1 i couldnt remove, why are you thinking its stuck? check you haven't missed a bolt
@daverhaci6369
@daverhaci6369 17 күн бұрын
Thanks for your prompt response! All the bolts are out. The casing spins freely. I used all kinds angles to pull it out but it doesn’t budge. I am guessing it might have got moisture inside and rusted inside the transaxle where the motor connects. I am thinking of removing the casing and see if it is rusted at the connection point and go from there. I would appreciate if you could let me know if you think of any other method to get it off the transaxle.
@backshed5295
@backshed5295 17 күн бұрын
@@daverhaci6369 ive never came across that. You may as well keep trying though , spray some penetrating lube or something in the direction of the shaft . You wont have room to slide the case off the armature sideways unless you remove the complete axle from the cart
@daverhaci6369
@daverhaci6369 16 күн бұрын
@ I was able to get it off after 2 hours of constant prying in between the casing and the transaxle housing last night. It finally came apart. It was rusted bad inside. I put the bolts back on and left them loose . I used a small pry bar and bunch of metal plates to close the gap in between the lip of the housing and the casing. I kept prying by pushing on the bolts with the support of metal plates until I had enough space to insert my pry bar in between. Who ever does this job needs to put on safety glasses for sure. That carbon dust came out from the casing after the motor popped off the transaxle was all in my eye. You were absolutely right. That little motor was very heavy. It felt like benching 300 pounds while trying to put the motor on the ground. I will try to upload a video soon. Thank you for your encouraging comments!
@backshed5295
@backshed5295 16 күн бұрын
@ all good mate👍🍺
Golf Cart Spits & Sputters
11:57
Cart Smart TV
Рет қаралды 13 М.
GIANT Gummy Worm #shorts
0:42
Mr DegrEE
Рет қаралды 152 МЛН
Golf Cart Brands to Avoid: Top 8 Worst & Unreliable Companies to Stay Away From
8:57
Golf Cart Cranks but Won't Run (Common Problem) Easiest Fix Ever!
13:43
Helping U online
Рет қаралды 218 М.
GOLF CART ELECTRIC MOTOR BRUSHES REPAIR AND SERVICE
18:12
FIX IT YOURSELF
Рет қаралды 5 М.
Testing Golf Cart Batteries with a multimeter
4:17
South Atlanta Golf Carts LLC
Рет қаралды 215 М.
Ultimate Golf Cart Makeover
20:04
Ultimate Rebuilds
Рет қаралды 581 М.
FRESHENING UP THE FRONT SUSPENSION ON A CLUB CAR GOLF CART
7:19
THEMOWERMEDIC1
Рет қаралды 60 М.
2014 Yamaha Drive, Gas - Quit Running While Driving
20:18
Kevin's Golf Carts
Рет қаралды 4,5 М.
PETROL OR GAS GOLF CART NOT STARTING HOW TO FIX IT YOURSELF
5:40
FIX IT YOURSELF
Рет қаралды 1,5 М.