GOOSE BETWEEN MICOM AND DIGIS | GOOSE BETWEEN P543 & 7SJ64 RELAY

[@kamranansari7428]

Thanks for your information about stval...today i am facing this problem

[@kamranansari7428]

Can we goose DPC command from alstom bcu to siemens?

[@baranitech]

yes can

[@haiderzafar6200]

If any changes are made in the micom station after exporting it to digsi than.... When we export the changed station again to digsi... Will we have to do the whole source part connection of goose in digsi all over again?

[@haiderzafar6200]

Is the procedure similar in case of reyrolle to digsi project?

[@clintonthangaraj4250]

You covered in all videos how the GOOSE message is send from ABB,Micom,Siemens relays and GOOSE message is received to ABB, Siemens but GOOSE receiving in Micom relay is not available in any other videos. If possible teach us how to receive GOOSE message in Micom relays.

[@baranitech]

i will make for you

[@Gurubimc]

@@baranitech Hi, Have you made this video for sending signals from Siemens relays to Micom relays. Keep up the good work.

[@ElmarAbbasov]

Have you made video? In spite of 3 years past it is actual😅

[@souvikdasgupta6363]

U didn't take virtual out put assigned for isolator status, in ur data set, how would it work then?

[@baranitech]

for sending single to IEC or IIE without virtual i/o we can take from particular tree if available .

[@souvikdasgupta6363]

@@baranitech what is IIE?

[@souvikdasgupta6363]

In PSL u took virtual output but when ur linking those to siemes relay, u r taking virtual input to link. Can u explain this? 🙏 please

[@killkillers6]

thanks for your video, can you do a video to make goose between Siemens relay (with digsi 5) and ABB relay (with pcm600) please ?

[@pankajgupta-ph6di]

Hi, have u done goose communication between micom to Siemens if so , please contact me

[@Thinakar110]

Why r u changing Mac Id in mcl file. Is it mandatory to configure in report control block for GOOSE? Can u help me through mail/whatsapp

[@kamranansari7428]

How to update micom icd file in Siemens iec station.

[@kamranansari7428]

No not this update....there is one option of update under iec station down to export and import.

[@kamranansari7428]

I have one micom relay p444 i have made some changes on that for led reseting through scada.....so i export icd file of micom and update the iec station by satation by selecting the icd. But then the relay goes offline to scada.

[@kamranansari7428]

@@baranitech but after sending this file my relay goes offline and also some goose in is not working

[@Thinakar110]

Really good effort. Very much helpful. Quality of content is really good. If you could help over WhatsApp it will be helpful in next level