Got a new CNC torch for my Arcdroid

[@JacksMt.Christian]

It is nice seeing your shop progress and improve. This is all stuff I would like to so, myself, at some point in the future as I can afford to do so. Good video, very helpful. God Bless!!!

[@6.8liter74]

Thank you

[@slrcustomguitars]

Thanks for the calibration demo

[@6.8liter74]

Hopefully it helps someone!

[@KwikFab]

I'm not planning on getting an Arcdroid but know someone that wants one. I skimmed through the manual for him and notice Arcdroid uses divided voltage for THC. However, it does not state at what ratio. Why did you go with 1/50 over 1/16? Can raw be used instead?

[@6.8liter74]

I haven't implemented THC. I started looking into it but the output from my Primeweld Cut60 is not acceptable for use with the arcdroid. I do believe it uses 1/50 voltage. @amp_mechanic has some good videos of what he did to set up THC. He ended up building an external voltage divider, which I believe he sells now.

[@Woody59er]

Did you ever figure out why the Droid shut down and you got shocked?

[@6.8liter74]

I believe it was the unshielded cat 5 cable. It has been quite a while since it has happened.

[@adam-oz1jo]

i see on arcdroids website it says not to use high frequency plasma machines.. have you noticed any issues?

[@6.8liter74]

I've had no issues, and I noticed the Primeweld cut 60 has been added to the approved machine list for machines built later than 2021.

[@KwikFab]

The CUT60 is not a high frequency machine.

[@adam-oz1jo]

@@KwikFab oh the website says its a high frequency no touch start

[@KwikFab]

@@adam-oz1jo it shouldn't, it's a blowback type. I own one as high-frequency cannot be used for CNC.

[@tjs_welding_and_fabrication]

How much are arc Droids

[@6.8liter74]

$2500 for the arcdroid + your plasma cutter

[@rainmaker3700]

Too many toys to buy, not enough money!

[@6.8liter74]

Amen to that!