GOT GAS, YOU NEED GAS!! BEGINNERS GUIDE TO MIG AND TIG WELDING GAS.

WE GO OVER GETTING AND SETTING UP YOUR WELDING GAS, FOR YOUR MIG AND TIG WELDINGWe now have merchandise.
‪@MillerWelders‬ ‪@rockmountwelding‬
Stickers and Shirts
If you want stickers please email me.
[e-mail]
Help your Channel with VidIQ
vidiq.com?afmc=5jd
Music by www.artlist.io
Connect with Jeepingmo:
WWW.jeepingmo.com
jeepingmo
jeepingmo
jeepingmo.tumblr.com/
KZbin: www.youtube.co...
/ jeepingmo1
Please note: We are an Amazon Affiliate program member, And We are paid by Amazon when you buy any of these products. We do use most of these products.
DJI OSMO Action Camera Bundle with Micro SD Card, Tempered Glass Screen Protectors, Carrying Case, and Must Have Accessories (55 Items)
amzn.to/2NptoPo
CYNOVA Osmo Action Dual 3.5mm Mic Adapter - Made for Osmo Action with Authorization
amzn.to/3fPQ0on
BOYA BY-MM1 Video Microphone KZbin Vlogging Facebook Livestream Recording Shotgun Mic for iPhone HuaWei Smartphone DJI Osmo Mobile 2,for ZHIYUN Smooth 4
amzn.to/2NrJJ6d
IENZA Replacement 3.5mm TRS to 3.5mm TRRS Patch Adapter Cable for iPhone Smartphone Movo BOYA BY MM1 Rode VideoMicro Mics
amzn.to/3ev4JVB
RAVPower FileHub, Travel Router AC750, Wireless SD Card Reader, Connect Portable SSD Hard Drive to iPhone iPad Tablet Smart Phone Laptop for Photo Backup, Data Transfer, Portable NAS, 6700mAh Battery
amzn.to/2YtQYAO
DJI CP.ZM.00000064.01 osmo Mobile 2 Handheld Smartphone Gimbal (Single Unit), Gray
amzn.to/2Ver3ep

[@jarikinnunen1718]

For small DIY weldings, blow torch is enough to shielding gas. No matter where CO2 come from. When use gasless welder with gas wire, polarity must change.

[@JeepingMo]

@@jarikinnunen1718 I agree, flux core and hardwire with gas are opposite polarity. Thanks for viewing.

[@RebuildRex]

A lot of good information! Great video!!

[@philbrennaman4572]

Great info once again, thanks.

[@omahanb1]

My Miller cuts off the gas if no arc. I will look for a purge line. I cracked the hose line but it was too high when I was welding.

[@JeepingMo]

What miller do you have. Are you looking to run a purge line also?

[@omahanb1]

@@JeepingMo I have a Millermatic Passport Plus. I have set the gas by filming it before but as soon as I pull the trigger and no arc detected the ball doesn't even settle before it cuts off. Today I cracked the hose but when I welded the ball peaked at full. I am not running a purge line.

[@JeepingMo]

@@omahanb1 i would check your ground. You also could try turning up your gas.

[@omahanb1]

@@JeepingMo Thanks.