Submodeling FE Analysis using ANSYS

[@shridharkumbhar6082]

THANK YOU

[@graspengineering9249]

Thank you for appreciation. Please connect with us on [e-mail] to receive future updates .

[@mathuuma]

Hi. Thanks for the video. One request. The voice is too low. I can hear only through headphones with maximum volume. kindly check your voice output in future videos.

[@graspengineering9249]

This is old video, we have imorived the voice in recents videos.

[@NTC]

could you please share the Ansys model?

[@praneshsb8979]

Hi, What is the DNV code for sub modelling guidelines?

[@graspengineering9249]

It is one of the technique of simplification refer based on saint venant principle.

[@mangeshbanale9741]

Do we need to apply load again in submodel, as we have considered that in global model??

[@graspengineering9249]

Yes. You should also apply local loads too, Loads on local model.

[@mangeshbanale9741]

@@graspengineering9249 can u explain the reason for the same??

[@hsg5630]

@@graspengineering9249 Hello sir, thank you for the video. Even I am looking for the same thing. While I am very clear that loads need to re-applied I am unable to find why. Please let me know.

[@marcink9595]

Hi! I have line body and trying to do submodel, but i cac't slice it. Is it enough to have line body with cross section to do it? If not, how can I convert it to solid body?

[@graspengineering9249]

For 1D line body sub modeling is not possible. You can either model 2d shell or 3d solid or else split line body and input displacement as boundary conditions from global model.

[@Suraj-jc7wb]

@@graspengineering9249 how to split line body!!!

[@puppallamuralikrishna8743]

I am trying to do submodelling at 3 different locations (Regions) from one global model. But the results are not matching for 2 regions. Results are matching for only one Region. Kindly give your suggestions for the same. Thanks

[@graspengineering9249]

Hello % Greetings! All Local models should match displacement of global model (at respective local model region). You should check the displacement at cut boundaries where read properly or not.

[@asn4186]

hi how can we convert beam to solid element or how can create this 3d shell model?

[@graspengineering9249]

From beam to solid is difficult but from solid you can extract beam model. for 3D shell modeling, we already created design modeler playlist with different modeling video, please kindly refer from our channel page.

[@bobshiu3159]

can you give the cad file?

[@graspengineering9249]

Please refer our blof link for CAD Model. www.graspengineering.com/category/design/fea-cad-geometry/