Gripper Mats™ - How to Hold a Magnetic Sign to an Aluminium Vehicle Truck Car - by Proper Design

[@paloalto8848]

r u on amazon?

[@krb7694]

Would this work for a magnetic light (on top of a vehicle) like a mailman would use? Would the wind be too much for it?

[@properdesignltd]

We don’t think that it would work unfortunately as there isn’t enough contact with the Gripper Mats vs the wind.

[@herbpressurewashinglawncar254]

I’m having the same problem I order mines from visaprint they will not stick

[@properdesignltd]

Our Gripper Mats can help you... properdesign.uk/products/new-gripper-mats-magnetic-sign-grippers-for-aluminium-vehicles

[@properdesignltd]

These will help you... properdesign.uk/products/new-gripper-mats-magnetic-sign-grippers-for-aluminium-vehicles

[@danielhornea2723]

Where can i find some?

[@alexanderbaron6521]

Where can I buy this product in US?

[@anonanon8974]

Can I put a regular non magnetic bumper sticker on it since it seems it would be much easier to remove then putting the sticker directly on the car?

[@properdesignltd]

Yes, we think that would work although it hasn’t been tested.

[@joshuacampbell9717]

Has anyone used this and it worked?

[@properdesignltd]

Yes; literally thousands of people benefit from these every year.

[@rh9118]

Hi, yes I have, definitely works, does not come off , even over 70 mph. However when peeling of car , needs a little force takes a little time, not something you would do every day. Definitely works to my surprise.

[@brycewilkey9752]

I need this but sold out

[@MyRealtorIvan]

Can this be taken off and on as much as I would like and continue to stick?

[@properdesignltd]

Yes, they do not lose stickiness as they do not work with adhesive. However, each time you take them off you need to give them a quick wash under running water and allow them to air dry in order to refresh the stickiness. You can do this time after time and they are just as good as when new. Many thanks for your enquiry.

[@stp]

Do u rinse them while they are stuck to magnet? Or do you remove to rinse both sides then reapply to magnet? Seems a lot to do if u have to remove every day

[@DoctorRickSanchez]

Eventually the wind will catch underneath since it's not flush to the car.

[@properdesignltd]

That’s not the case if the mats are properly laid out and looked after. It’s hard to explain but the sign is actually pressed onto the vehicle due to the way the air moves down the vehicle. It’s due to low and high pressures like with an aeroplane wing. Saying that, if the mats are not properly laid out and cared for, the adhesive properties will be weakened and the sign may peel up. Follow the instructions carefully and contact us for advice if required. Many thanks.