The new drive belt I fitted actually goes through the bottom of the motor bearing so saved me taking the whole top of the machine apart.
Пікірлер: 9
@selmansenkalp Жыл бұрын
Wish you’d show the whole process lol.
@harveysvintageaudio Жыл бұрын
I would like to but I do not have the space to setup a camera etc
@mikesharpe32905 ай бұрын
where did you get the replacement cam from? opened mine up to find the rubbery bit had broken in two.
@mikesharpe32905 ай бұрын
Think I may have answered may own question. is it just a pinch roller (about 10 mm or 13mm including the shaft)
@mely19556 ай бұрын
On the machine I have the selector has jammed in the reverse position any ideas how to free it up repair really appreciate any info
@mikesharpe32905 ай бұрын
mine did the same... it was because the cam broke. taking the top off and pulling the metal lever down while turning the selector allowed me to shift it back to stop.
@harveysvintageaudio4 ай бұрын
The cam must have broke in pieces, common problem. But you can use a Cassette deck pinch roller to do the job.
@mikesharpe32904 ай бұрын
@@harveysvintageaudio Thank you. It's back in the stack of to be fixed jobs. I've got the little shaft saved and will test with a pinch roller from a tape deck. One thing I did notice with this deck is it took some time for the motor to kick in from power up (about a minute) so if anyone else out there thinks the motor is broken give it a minute it might just kick into life.
@harveysvintageaudio4 ай бұрын
@@mikesharpe3290 Maybe the belts need changing, they normally do go bad after a few years, especially the original rubber ones. ps. Good job you have the little shaft as they are impossible to get hold off.