Guide: How To Lay Underfloor Heating

Learn how to lay underfloor heating from an expert. Underfloor Heating Systems Ltd have years and years of experience laying warm water underfloor heating. Includes information on every process from preparation work and products to used to finishing touches.

[@shanghaiearthmother4785]

probably the most detailed UFH installation video ever seen

[@tuzzotuppo9566]

You're a total beast when it comes to Underfloor Heating!

[@flooriqengland1101]

With the use of FlooriQ Milling Machines, this process is made even easier :) great video, thanks for uploading x

[@juliadallen1490]

Very helpful in helping understanding and construction.

[@ershadtaymourtash2529]

Dear Expert , Thank you for the brilliant explanation. My question is whether we can install new laminate on top of old ceramics while using a wet floor heating system. Could you please guide me on whether this would prevent efficient heating conductivity, increase energy consumption, and how it might affect moisture levels? Additionally, what steps can I take to control these factors? Best regards,

[@plamenivanov4331]

I have 2 floors house first floor is living room and kitchen and hallway and the second floor is 2 bedrooms and hallway 110sq.m total how many manifolds should I install?

[@handle1196]

When you mention the edge insulation, if this sits on top of the base insulation, then you ad the dpc membrane, does the blue expansion edging go against the wall as well as or instead of the kingspan? From the concrete wall inwards, is it: 1.Wall, kingspan edging, membrane, Blue expansion strip, floor screed? or 2. Wall, membrane, blue expansion strip, screed?

[@maurifederi5817]

Hi. Is it posible to heat shower floor? And all bathroom?

[@jmf5392]

On the blender joint under the pump is the flow inlet from the boiler below and the return to the left ??

[@javadkarimi9735]

Is is sortable for laminate floors? Please if anyone know

[@canadapainter658]

a great video...

[@ifti0016]

Yesterday my builder applied 100 mm screed...is it ok??

[@ajmalshabir4089]

It will take longer to get it warmed will certainly decrease the effectiveness but don't worry it will do the job

[@AN-ks2ep]

yes, we have close to 5 inch inch and works prefect

[@tnt1602]

Damn, I wish you are available in my country

[@taitlawrence]

Why does it have to be tested to 6 bar when it’s only going to be around 1.5 - 2 ?

[@underfloorheatingsystemslt4824]

Just to make sure there are no leaks, normally 24 h. Our pipe is 10 bar and 95 degree C temp,. High quality.

[@daiboy8076]

Is this saying it is 70 day drying time for a 50mm screed?!"!

[@underfloorheatingsystemslt4824]

1-2 mm a day

[@daiboy8076]

@@underfloorheatingsystemslt4824 Thanks for the prompt response - when would it be ok to walk on

[@underfloorheatingsystemslt4824]

I would check with the screeders.

[@omranabobakr4582]

هذا عمل جيد جدآ

[@جعفرزعلان-ش8ع]

Welcome if you can send details about this company and address Is there a branch of the company in Iraq Basra

[@emrahbatur2606]

Ccokk güzel ya

[@MarcelHVAC]

yok

[@The160879]

2 months lol 😂

[@simonbeckford3025]

69 days is more than adequate sir..

[@AlexS-mf2kc]

soo expensive. id rather 100000 feet of water hoses.... id rather simply install a normal heating. srew that. and what if it BRAKES???

[@goodbyetothepeople92]

Alex S what if you learnt to spell?

[@strangedays4]

Do whatever you feel is best