Schneider Electric Zelio logic controller PT100 temperature probe wiring/set up, sample program. Eng

[@kennysmeesters2313]

Thanks for your video's! You are helping me alot.

[@evrardsas2844]

Hi, thank You for share You experience, i'm working in a proyec, but i need messure and save the info from the temperature sensor do You nowk how in can do this, i have a zelio sr3b101bd

[@Tholin378]

I have done some basic control work with Zelio in the past. I’ve never had to use analog inputs until recently. Which sensors would you recommend using for temperature control?

[@IGSElectronics]

What is your temperature ranges you are planing to work with?

[@Tholin378]

@@IGSElectronics I am in Canada and will be measuring outdoor air in a range of -40C(-40F) to +40C(104F)

[@IGSElectronics]

@@Tholin378 Standard PT100 probe will do bud, the set up i did in the video will work perfectly.

[@Tholin378]

@@IGSElectronics Thanks for the replies. One more question. If using multiple temperature inputs for the same program I would need an analog io extension module for each temperature probe correct? In my example I would be comparing outdoor air temperature to a room temperature and then sending out a 0-10v signal to a damper actuator based on those readings.

[@IGSElectronics]

@@Tholin378 Had a look in to the hardware manual and it looks like that is the only unit, so yes you might need to have for each one of them. But do check the manual in description to see maybe i missed something.

[@kumarv8860]

Good seminsr