Your English speaking is so nice for non native speaker ❤❤ Very knowledgeable tutorial Keep it up
@JakobHarlev Жыл бұрын
Such nice content :) Thank you so much. I just recently found your channel. I will be watching a lot of your videos from now on! One question, why are you talking about an S400 PLC on this video and the previous one? I only see you using a S1200 and S1500 on the video.
@bendjakovic955 Жыл бұрын
Bloody brilliant!! You have a new subscriber Ingus 👍
@Aeeeeelex Жыл бұрын
You’re the best. Keep up the good work!
@IGSElectronics Жыл бұрын
Thanks! Will do!
@tpd-jy7qm5 ай бұрын
Thanks for explanation, can you explain how to convert the results to RPM? Which encoder did you use here?
@tpd-jy7qm2 ай бұрын
I am using Push-Pull encoder, and i conected A, B and Z to 0.0, 0.1 and 0.2 inputs of 1215C PLC. Program is counting something, but I am not sure are reading correct or not ("countersingle phase" doesn't read anything at all). Can someone explain how this could be fixed, so it can work properly with my encoder? Thanks.
@فهيمعليعبداللة29 күн бұрын
Hello How are you? I am Fahim and I want to help you I have a device plc cpu 1214c that has been programmed and a protection key has been placed and I cannot open the program and I want to delete the program from the device. What are the steps to delete the program from the device? Thank you for your cooperation
@1986ah Жыл бұрын
What if the counting value reaches the upper limit of a double integer? How could we reset it again?
@veys96559 ай бұрын
it reset it by itself. Then it start again at the begining value!