GYEON BATHE + VS. TERSHINE PURIFY S - NON-POLISHED CAR

[@ashc3765]

Quite surprised by your results! I’ve had amazing results with bathe+

[@erikandersson655]

Sådär blev bathe:n för mig med, men när jag provade mer mängd och aktivera schampot med högtryckstvätten i hinken så blev det en helt annan produkt. Den ger nästan samma avrinning som gyeon wetcoat sen jag började "göra rätt".

[@AndreasSchwarzinger]

You can drastically improve the hydrophobic effects of Bathe+ by applying it in a different way: wash the car with a regular soap, rinse, and the apply a small amount of pure shampoo to the wash mitt and „wash“ the car again, the rinse.

[@nordicgloss]

will try to put it straight to the wash mitt next!

[@ulfw9610]

Det måste vara omöjligt att få så uselt resultat med bägge dom medlen. Har använt bägge och det är inte i närheten av det där.

[@beyondcleanvictoria7662]

I believe this video has done no justice for either product as I'm very familiar with the bathe plus and I noticed he installed it incorrectly for maximum hydrophobicity. Our favorite on a day-to-day basis is washing the car with a regular soap then applying Dave plus to a foam Cannon one part product to four parts water. Doing a pass over the vehicle surface letting it dwell for 30 seconds and rinsing it off. immediate hydrophobic effects that last upwards of one month for regular vehicles.

[@Eqinofc]

You do realise that the purify s is not supposed to be water repellant? That product is called Refract.. Purify and purify s is a pure "gloss shampoo" so what you should have done is compared the gloss on each side.

[@nordicgloss]

I know, but many people thinks that it leaves a water repellant layer, I just want to show that this is not because of the Shampoo, its more likely because of a polish and wax applied to the car beneath... even if tershine says that it ”boosts”the repellant effect after 4-5 washes... but yes it gives a very good gloss and shine, but this is hard to catch on camera though..

[@DetailingBreakdown]

I think u rinsed the Purify onto the Bathe+ side. U should rinse from the middle outward and try not to get each product on the other’s side.

[@nordicgloss]

Yesh true, but in this case I do think it affected that much, but if it was a wetcoat for sure…

[@zhar9393]

Not my experience with the bathe+. You must have done something wrong.

[@nordicgloss]

Yes, many have pointed out that there can be something wrong with my batch..I need to try another one.

[@zhar9393]

@@nordicgloss perhaps you didn’t dilute it properly, some areas may have different water hardness and thus require a more or less shampoo.