Handbrake / Parking brake adjustment - get the right count

[@tmd1505]

Wah, neat and clean and nicely done! 👌

[@arififtikhar420]

Very important to adjust

[@TheWrenchWiz]

Never seen any mechanic adjust it.

[@muhammadasimsaleem3696]

Thanks

[@1marcelfilms]

Much easier to pull handbrake 1 or 2 clicks first and then tighten cable until the wheel starts rubbing.

[@iftekharameen4058]

important information

[@hansheulu]

超級感謝

[@RUS-dv5sm]

The rear wheel should rotate freely when the handbrake is off or should we have some resistance (like the wheel cannot make a full turn) when handbrake is on? I have been told that there should be some resistance so that the brake works properly and immediately when pressed.

[@TheWrenchWiz]

There some be a bit of resistance. Not turning a full round is too tight imo. I have it set where it turns a few rounds, you can also hear it rubbing against the pad material. If too tight your just wasting material.

[@RUS-dv5sm]

@@TheWrenchWiz ok thanks will adjust mine...