Harbor Freight Badland 9000 lb Winch Install onto my trailer Complete Bolt-on Setup

Badland Winch - amzn.to/3jp6Amd
Hitch Extender - amzn.to/3WEX6l9
Step Hitch Bumper Mount - amzn.to/3HTdYAk
www.maxpeeding...
Use coupon GBH to save 10% on all orders.
My Favorite Products
Wheel Bearing Tool - amzn.to/33IplZZ
Milwaukee Ratchet -amzn.to/3EtpNJp
Jack Stands - amzn.to/3lvA5A2
Cameras used in this video
My GoPro - amzn.to/2YQ3OGZ
My Mirrorless Camera - amzn.to/2HzzFFT
Decals available for purchase here - garagebuilthon...
Send me stuff here!
Jon Widmer
PO Box 13594
El Paso, TX 79913
/ garagebuilthondas
Thanks for watching!
Disclaimer
"Due to factors beyond the control of Garage Built Hondas, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Garage Built Hondas assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair videos. Due to factors beyond the control of Garage Built Hondas, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again, any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Garage Built Hondas."
DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll potentially receive a small commission at no cost to you. This will help support the channel and allows us to continue to make videos like this. Thank you for you support!

[@teslamac5348]

Too funny. I just did a very similar thing with a Badland 5500. I didn’t realize the 9000/12000 came with a control box. I used a HF pelican style case and made a control box. Ill use mine to roll shop equipment onto a trailer for a move. Mounting on a 2”receiver allow me to use it on the trailer, a truck, the side by side, etc. I’m planning to use jumper cables to the vehicle battery for now with the motor running. It will get infrequent use but is easily shared if anyone in the fam needs it.

[@crxdrew4974]

Nice to be as prepared as possible, especially when going out of town!

[@GarageBuiltHondas]

It sure is!

[@freda1078]

Check into the rope instead of the cable. You will get better results with it and it is easer to handle.

[@frankdove4869]

I like the way you did your watch setup

[@nevadabadger7925]

Greetings from Reno, Nevada. Nice project execution.

[@GarageBuiltHondas]

Thanks!

[@TimSmith-ik2sf]

Sounded like the battery was to low when the 9 k winch was hooked up

[@maxboost4042]

Congrats on everything happy holidays

[@frankdove4869]

Watching your video installing that the battery you got for the winch looks like a gel battery and that's better

[@GarageBuiltHondas]

Yes, it's an optima. Mines a little old but a new fresh one would be cherry!

[@frankdove4869]

Put a board on your deck where your cables running to protect your deck on your trailer

[@markdonahoo2912]

Just lay a 2x4 board along the peak of the dovetail, the cable will rub into that.

[@GarageBuiltHondas]

👍

[@kirbizle]

Sweet, we literally just wired ours up yesterday after it sat on the trailer for a few months lolol

[@GarageBuiltHondas]

Right dude. I've been wanting one for a long time and finally just bought one.

[@kirbizle]

@GarageBuiltHondas now hopefully you'll never need it! 😆 That was our logic, in September I needed it and we were lazy and didn't finish the install. Now that it's done the car will never break! 🤣

[@GarageBuiltHondas]

@@kirbizle right dude!

[@fernandorodriguez4435]

Hey man where do you get those ramps ?

[@srl2634]

You need to be mindful about your line when pulling with the load,looks like you fouled up the spool and burned out the motor cuz you stuck the cable around the winch.just saying.

[@scottzimmerman7667]

Really brave not having it hooked up to your tow vehicle while loading. It could have flipped the back of the trailer down with the weight of the car coming up on the trailer.

[@GarageBuiltHondas]

When it wasn't hooked up I had put the two supports down to avoid that from happening. When it was hooked up to the truck earlier in the video I had them up.

[@petergardiner4359]

Did you ever think of turning the wireless receptacle around 90 deg.

[@TheCSRTech]

Or 180 degrees like he did?

[@jacobparra3131]

Merry Christmas 🎅

[@GarageBuiltHondas]

You too!

[@gonestag391]

Anyone else confuse about the 9k winch failing? Probably a Friday make.

[@GarageBuiltHondas]

I'm unsure. Maybe I just got a dud. I've used the winch twice already with no issues thankfully!

[@Auxbeam]

Hi Do you need some great lighting for your car to help you better driving, off-road? We're the pro auto lighting manufacturer for nearly 20 year and we're looking for sponsorship!

[@GarageBuiltHondas]

What kind of lighting?

[@Auxbeam]

@@GarageBuiltHondas headlight, fog lights, light bulbs, light bar, all kinds of lights that can fit different types of vehicles:) We're happy to send them as sponsorship

[@GarageBuiltHondas]

Can you send me a link to your product?

[@Auxbeam]

@@GarageBuiltHondas Sure I send them to your email!

[@Auxbeam]

@@GarageBuiltHondas Hi Do you receive my email:)

[@isaiahpeters6432]

🔥🔥🔥🔥😇😉🍻🍺

[@peanuthead5730]

Harbor frieght tools arent always the best im realizing

[@jcw9396]

10 minute video if you didn’t babble so much ……shorten the length and focus on the video

[@GarageBuiltHondas]

Sucks there's not a fast forward or skip forward option, huh?