In this set up I used two tow clamps. The vice also has a 5/8" square metal bar bolted to the side, flat with the table. The bar slides through a C shaped dog that is held by a stud in a T-nut. Tightening the draw nut on the stud against the C shaped dog pins the bar to the table and secures the vice. Very fast to adjust horizontal vice position, best for small hole drilling.
@levirugheimer31313 жыл бұрын
Does that drill press have an auto down feed?
@bretthl13 жыл бұрын
Yes. I would not consider a drill press for metal without power down feed especially for production work.