Harley Sportster 48 with SP Concepts Lanesplitter Exhaust Install

[@DevisMizza]

Are you able to measure decibels with a mobile phone app at 1mt beyond the mufflers, when you switch on the bike but Also at 3000 RPM? Thanks you very much.

[@Lucky-xj8vz]

What tuner did you use for the air cleaner and SP exhaust setup?

[@kevlarxkoffee]

Dynojet PV4 tuner with a custom fuel map from Fuel Moto, but I suggest the Vance & Hines FP3 tuner over the Dynojet. I have a riding video on the tuner 🤙

[@Lucky-xj8vz]

Thank you, brotha. I just ordered my spc. Where did you get your new gaskets from? ​@kevlarxkoffee

[@kevlarxkoffee]

HD dealership. I like the oem ones. Others should be fine too, like if you were to order them on revzilla or something.

[@jensfosbk1601]

I wonder if this will fit my 06 XL1200R. Gonna have to go check out how my brackets look.

[@kevlarxkoffee]

Send SP Concepts an email, I'm sure they'll help you out. I love the pipe so far 🙌

[@justinturner4850]

Use a pick to remove the exhaust gasket. Not a flathead screwdriver 😬

[@kevlarxkoffee]

Like a toothpick?? 😂 I only have a flat head laying around 😅

[@donbraham411]

Linda is looking 👀 good 🤓👍

[@reynosoasndres]

What tune do you have or are you running exhaust with it ?

[@kevlarxkoffee]

Dynojet PV4 tuner with a custom map tune by fuelmotousa. Check out my stage 1 upgrade and map tune videos 🤙

[@donbraham411]

Sound is awesome 👏

[@bakerm1972]

Adjust the clutch and stop the surging

[@kevlarxkoffee]

It'll be fixed when I get my 5K service soon lol 😅

[@bibbpimpin]

Any difference in performance that you feel?

[@kevlarxkoffee]

Amazing performance 🔥🙌

[@eddie_bee]

So I have my bracket on top right now and ended up adding washers to the mid control to space the brake pedal out. I mounted it on top for the little extra ground clearance due to scraping on right turns. Seen you around town more lately, to bad Im in the car when I do.

[@kevlarxkoffee]

I'm might try the washers and see. I've been riding it good tho. Haven't scraped yet 🙌

[@Lucky-xj8vz]

@eddie_bee same man, I'm scraping all these turns. It would be dope if you can show me your washe setup to raise that pedal brotha.

[@timmitchell8501]

@eddie_bee, @lucky-xj8vz Mine scrapes a ton too. Trying to figure out how to get it as high as possible. Might have to make a custom bracket. @eddie_bee, I think you’re talking about putting washers at the interface between the frame and the curved bracket that the brake pedal and footpeg mount to, right? That’ll move your peg and pedal outward slightly to give clearance so that the brake pedal doesn’t hit the pipe.

[@Lucky-xj8vz]

@@timmitchell8501 exactly 💯

[@eddie_bee]

@@timmitchell8501Yes. It's between the pedal attachment and frame. Think I have 2 thick washers in there. When you place the muffler over the rear bracket it moves the pipe closer to the pedal.