Do you drain the filter or shut off external valves to prevent pool or hot-tub water from coming back up into housing once you 'pop the top'? You seem to be missing a few other steps. Most suggest gasket adhesive on one/bottom side, and lube on top side Also, valve handle setting position as well as lining up top/lid back to original location to housing.
@MrDeuce19564 ай бұрын
How do you replace the lateral assembly on the Hayward SP0710X62 side mount filter tank?
@chrisroselle73077 жыл бұрын
Can I just take out the pin and remove the handle and replace the plastic washer under handle without taking everyting apart?
@jurbalap5 жыл бұрын
will this fit the pro-series S244T 24" with Vari-Flo top-mount filter control valve, plastic handle broke on mine.
@1GuitarHack9 жыл бұрын
I'm having some trouble with my filter i have no pressure when it is normal filter mode, also sand is shooting back into the pool in this mode,when i turn on the rinse mode sand fills in the glass The pump is working fine and i have a good flow of water going into the filter and returning to the pool but like i said there is no pressure reading on the gauge and sand is being shot into the pool,any advice would help
@chimi19247 жыл бұрын
Canadian Guitar Hack I have the same issue. Did you find the issue? Was it the valve? If yes, did you buy a new one or could you repair it? Thanks
@samanthamoran7627 жыл бұрын
Canadian Guitar Hack could be your laterals inside your filter are broke
@1GuitarHack7 жыл бұрын
Samantha Ralston Thanks for the response ,,, it was the laterals inside the filter 2 were cracked .I did replace it ,,but after about a week I started getting sand in the pool again,, so not sure what is going on now.
@carissajarvis24248 жыл бұрын
how do you measure a multiport valve so you know what one to order?
@sdnlawrence56404 жыл бұрын
Extremely worthless video, you (sorta) showed us how to loosen a screw, except you didn't even do that since it's a bolt & nut! 😡