HCD3 Presser Foot Height Adjustment

Follow this procedure to adjust the presser foot on HCD2 and 3 series 15-needle single-head embroidery machines. Note that you can optionally leave the presser foot height at the factory-recommended 1.5mm above the plate, or lower it to just touching the plate as an alternative. This procedure is the same for HCD2-1501 and HCD3e-1501. IMPORTANT: For the HCD3-1501 Servo, you may need to activate the BRAKE feature in maintenance mode to hold the shaft at the adjustment height (zero degrees).
Learn more about embroidery machines from HappyJapan from TexmacDirect at happyjapan.com