Thank you very much for your support !. I really appreciate it 👍👍
@ozproductions11172 жыл бұрын
Thanks for the vid. Just changed an H4 headlight bulb on third attempt. As usual once you have done one, the next time will be easy. The main problem is removing the black socket from the rear of the light bulb before you remove the rubber gasket. The manual implies you should squeeze and pull backwards. I was assuming there were some tabs which need depressing to get it to release. There are not. It really is just a case of pulling it back firmly and the bulbs tabs just slot in/out. I found mine were really solid - three people all tried in vain. I had a closer look at the socket on line and once I realised there were no tabs to depress and no wiring to damage on the sides I used a plumbers wrench to grab the socket rear - couple of wiggles and back-pull and off it popped. Easy peasey - Why has no one mentioned this before? Please tell everyone - shout it from the mountains - no copyright. Yes I am enjoying my cup of tea and biscuit victory moment.
@briangribben98328 ай бұрын
Thank you - I followed your instructions and replaced headlight bulb. It took a lot of wriggling to remove the connector but got there in the end.
@screwsnutsandbolts8 ай бұрын
Thanks for watching !
@Wasserverschmutzung2 жыл бұрын
Thank you for the high quality close up photos! I had a problem with beam not being formed correctly and thanks to you I realized my bulb dropped low when I was putting on the bracket! Corrected it and now it's as it should be 🎉
@screwsnutsandbolts2 жыл бұрын
You are welcome !
@sagar087 Жыл бұрын
Btw I just wanted to ask whether K12 has just one bulb that's used as high beam and low beam??
@screwsnutsandbolts Жыл бұрын
Yes it's a single H4 bulb.
@andrealovekoi1315 Жыл бұрын
Sorry we necessarily need to disconnect the battery negative side??
@Kathyelyn Жыл бұрын
i had three different cars and never disconnected the battery while changing bulb
@PhilipBaker-sf4yv Жыл бұрын
@@KathyelynPraise be to the Lord Jesus Christ that you are still alive to tell your story!
@jorgem8435 Жыл бұрын
¡Gracias!
@screwsnutsandbolts Жыл бұрын
Thank you very much for your support ! 👍👍
@jacquelinerudd441428 күн бұрын
Excellent video. Thank you, changed mine before hubby came back from walking dog. 😊
@screwsnutsandbolts28 күн бұрын
Good job :)
@spinspittah9533 Жыл бұрын
Hello! Anyone know K12 headlight wiring Diagram Common side is Positive or Negative ?
@PR_nick Жыл бұрын
Is it possible to get Honda civic H7 Bulb Removal and Refitting?
@screwsnutsandbolts Жыл бұрын
I don't have access to a Civic, sorry
@seyiralemi2 жыл бұрын
you don't shoot Peugeot 206 videos anymore? waiting for new 206 videos.
@screwsnutsandbolts2 жыл бұрын
I don't have the Peugeot 206 any more, sorry
@lucamoio2643 Жыл бұрын
E lo stesso procedimento dall'altro faro???
@screwsnutsandbolts Жыл бұрын
Yes it's the same
@lucamoio2643 Жыл бұрын
@@screwsnutsandbolts si deve scollegare il cavo batteria????
@screwsnutsandbolts Жыл бұрын
You can leave it connected but make sure the lights are switched off :)
@carlospaulino78345 ай бұрын
The dip headlight and the first set (morning or meeting light ) is the same h4?
@screwsnutsandbolts5 ай бұрын
The H4 is the dip headlight and the high beam
@piggo56454 ай бұрын
good tutorial! this is my first car and i’ve never touched under a car bonnet before but i was able to replace the bulb perfectly 👍
@screwsnutsandbolts4 ай бұрын
Thanks for watching !
@IonatanD10 ай бұрын
Foarte util! Multumesc din suflet!!!!
@screwsnutsandbolts10 ай бұрын
You are welcome !. Thanks for watching !
@hh_Lutik Жыл бұрын
Большое спасибо, мы до того как посмотрели ваше видео чуть пальцы все не сломали, маялись 2 часа и это не преувеличение
@screwsnutsandbolts Жыл бұрын
You're welcome !
@christopherwilson4003 Жыл бұрын
Can also take out the 2 bolts holding the unit .Whole unit lifts up for better access
@screwsnutsandbolts Жыл бұрын
Unfortunately there's a third bolt holding the front outer edge of the unit, behind the bumper. You can see it here: kzbin.info/www/bejne/Zp-3f2mpr52FZ7c
@christopherwilson4003 Жыл бұрын
@@screwsnutsandbolts Yes there is ....But removing the 2 bolts means u can lift it up enough to get more access... Honest guv....lol...
@screwsnutsandbolts Жыл бұрын
Just be careful not to put too much stress on the remaining bolt bracket or it could snap
@christopherwilson4003 Жыл бұрын
Yes very true . I'm loving all your videos
@screwsnutsandbolts Жыл бұрын
Thanks !
@Reformedbee34132 ай бұрын
Great guide! Thanks
@screwsnutsandbolts2 ай бұрын
You're welcome, thanks for watching !
@tw-ij3kc3 ай бұрын
My plug just refuses to come out. I nearly broke the retaining spring and it's still not out.
@screwsnutsandbolts3 ай бұрын
They have a habit of getting firmly stuck on the pins. You'll just have to keep wiggling the plug and it should come off eventually.
@MidoBroski Жыл бұрын
Really useful video thank you, managed to change the lights! One question, I've also changed the side light bulbs but they don't seem to be working, also checked the fuses and they seem fine. What do you think the problem could be?
@screwsnutsandbolts Жыл бұрын
Were they regular or LED sidelight bulbs ?
@MidoBroski Жыл бұрын
@@screwsnutsandbolts LED
@screwsnutsandbolts Жыл бұрын
I think led bulbs only work in one direction. Did you try taking out the bulbs, turning them 180 degrees and refitting them ?
@MidoBroski Жыл бұрын
I'll try this tomorrow, thank you for the tip👍🏻
@ismaelestremera28322 жыл бұрын
Greetings very well explained I would like you to also explain how to fix toyota yaris 2007 I have one
@screwsnutsandbolts2 жыл бұрын
I don't have acces to one, sorry
@Sevan59 Жыл бұрын
what is motor wiring?
@screwsnutsandbolts Жыл бұрын
The motor adjusts the height of the headlight beam
@Sevan59 Жыл бұрын
@@screwsnutsandbolts thanks
@bestdoc1954 Жыл бұрын
Thhankyou forthe ideal demonstration, with fotos, in other clips the demonstrater works with hands in the motor, you don‘t really see the actual process. the fotos dhow the site and the process ideally
@screwsnutsandbolts Жыл бұрын
You're welcome, thanks for watching !
@PR_nick Жыл бұрын
Well done. Thank you.
@screwsnutsandbolts Жыл бұрын
Thanks for watching!
@yair4832 ай бұрын
Thanks a lot man🙏🏽👏🏽
@screwsnutsandbolts2 ай бұрын
You're welcome !
@luisvasconcelos8742 жыл бұрын
Excellent video, I just changed my wife’s ones, i installed led ones and they are brilliant 😊❤
@screwsnutsandbolts2 жыл бұрын
Thank you !
@subhanuddin30092 жыл бұрын
good..job, I m watching ur vedios regularly.. I have Yaris Toyota 2002,,for last few weeks .it's clock setting is out..kindly make a vedio on it.