heat press keeps shutting off

[@hasandominick7533]

I had the same problem I replaced the reset switch now I’m go to go ..

[@cerailynpaul6721]

Currently having this issue. Would you happen to know the brand of this press? I have the exact same one but I purchased it from someone without the box.

[@sharonhennessey4004]

mine shuts off at 145 degrees and shows threee dashes

[@ravnski2190]

any links to these parts to replace or videos available, I'm going thru the same issue. ty

[@missygaffney6428]

I found the switch at my local hardware store but you can buy online they're not expensive

[@ravnski2190]

@@missygaffney6428 ty for responding. I ordered the on/off switch and also the reset button. overall was the process fairly easy to complete?

[@missygaffney6428]

Yes it's very easy to swap them

[@lwilli44]

What is the solution for this problem? PLEASE HELP ME. I have the same exact heat press

[@missygaffney6428]

Replace the switch is the resolution but finding the right one is difficult because I ordered a few that listed the right number but sent the wrong one. You need a KCD4 DO NOT TRY TO PUT A KCD2 it will immediately melt and can cause a fire

[@lwilli44]

@@missygaffney6428 Thank you so much for a quick response. I would open the back correct. You should do a video tutorial. I am not mechanically inclined. But I can follow directions.

[@missygaffney6428]

@@lwilli44 yes you will need to open the back panel to access the side clips on the switch, then you can change the wires.

[@lwilli44]

I put in kcd4 on Amazon and it also says kcd2. I hope it's the right one. Will I know the difference between the two when it arrives?

[@lwilli44]

I'm having an issue getting the connectors to come off? Did you have that issue? What do I need to get them off