Hellcat Fuel Pump Zip Tie Mod

[@AmericanGlassInc]

Car wasn't running right after a shop installed my dual pump had to completely go through it. Found there was a little bit of play in that line possibly causing that high-pitched squealing noise from my previous videos. Was also having hard starts and car would die flat on its face sitting in traffic when in gear. Looks like they did not install the lower clip. The noise was coming from the passenger side ended up taking that all apart to diagnosis. To get that clip you got to buy a $300 hose from Dodge so zip ties it is

[@JewelSyde]

What psi was your pumps reading when it was loose before the zip tie method. I think I’m having same problem but tuner saying I need new pumps because I’m only reading 30 psi of pressure on full throttle but I believe my lines where missing the red clip as well

[@Mp.Fabrication]

Mine reads 7Psi and can’t figure out the problem already diagnosed the entire car. However I am running a fuel cell and can’t find the fuel pressure sensor

[@AmericanGlassInc]

Hi sorry for the late response yes it was around 30 to 35 psi even dropped lower to about 28

[@AmericanGlassInc]

​ I would replace that fuel pressure sensor with a GM specifically from a z06 corvette