Yeah, did all that a million times, does not fix the problem. Want some other answer that says its something other than the idle jet being clogged, because it's not. I can fill the idle jet well with solvent and it will siv right through it. Rebuilt this thing with new parts 50 different times, putting it on and off again, with the same problem. Only runs on choke, and stumbles when you twist throttle. It's not the idle jet.
@dakotawilliams3294 ай бұрын
iF YOU HAVE REBUILT IT MULTIPLE TIMES WITHOUT ANY CHANGE YOU NEED TO LOOK AT THE GASKETS AND EVERYWHERE THERE IS A PLACE AIR IS LEAKING IN WHERE IT SHOULDNT BE.
@choppergirl4 ай бұрын
@@dakotawilliams329 Well, there is only one short rubber boot between the carb and the engine, that goes over the carb and is tightened on with a bog standard adjustable steel clamp. I have one more trick to try, and that's to take the carb off again, take off the rubber parts that will swell, and soak the whole carb for a week in a solvent like Berryman's B-12.... considering I don't have an ultrasonic cleaning machine. The idle jet is not removable, so I'm like, well, what if I soaked the whole bloody thing in whatever... Right now I just put half a can of B-12 in the gas tank (super solvent rich), and drove it to the nearest gas station 13 miles away to tank up and back... goosing it all the way running with choke on, set for maximum power, and though it stumbles and if I rev it I can get past the big dead spot.
@diyjeff1838 Жыл бұрын
Nice work!!!
@nwmotogarage Жыл бұрын
Thanks!
@10DKB9 ай бұрын
Nice. New air filter as well?
@donbosco47463 ай бұрын
I tried that but didn’t work! It’s something about mikuni style that sticks the cable in the center pin!
@FRANKLIN-vu1vn3 ай бұрын
Put new carb on 89 bayuo 300 4x4 and wont run with choke off ?? And choke cable is really stiff to out back in off position
@christianlemonade535511 ай бұрын
What do you spray to clean the stuff up ?
@tormado11 ай бұрын
Brake clean
@elusive3237 ай бұрын
Thanks.
@ontheopblockofftheopblock3472 ай бұрын
OK what cleaner do you have in that black pressurised bottle cause I be sitting there for half hour cleaning that gunk off the exterior of the carb haha
@Hajfbwbskdk2 ай бұрын
Gonna be brake cleaner or gas
@yobro442310 ай бұрын
What was in the pressurized black tank that you sprayed the carburetor with
@abdullahalaaaliraqi17110 ай бұрын
Brake cleaner
@Rokynutz9 ай бұрын
How much does the bulk brake cleaner and that pressurized can run? I like that!
@loiadias11 ай бұрын
i had text you on tik tok about my 2006 crf 450r
@timmckenzie83217 ай бұрын
Pilot jet
@californiadreaming92166 ай бұрын
THERE IS NO POINT IN CLEANING CARBURETORS UNLESS YOU CLEAN OUT FUEL TANK ALSO. OTHERWISE CARBURETORS WILL JUST CLOG UP ALL OVER AGAIN.
@nwmotogarage6 ай бұрын
CARBS DONT CLOG UP FROM DIRT. THEY CLOG FROM FUEL SITTING AND BECOMING MUSH
@californiadreaming92166 ай бұрын
@@nwmotogarage UNLESS OF COURSE THE MOTORCYCLE IS OLD AND THERE IS RUST IN THE TANK. YOU CAN ALSO PICK IP DIRT IN YOUR FUEL AT GAS STATIONS. HAVE A NICE DAY.
@californiadreaming92166 ай бұрын
@@nwmotogarage INCIDENTALLY, GASOLINE DOESN'T TURN INTO MUSH. IT TURNS INTO VARNISH.
@CosmicSeeker694 ай бұрын
@@californiadreaming9216 YOU CAN ALSO PICK IP DIRT IN YOUR FUEL AT GAS STATIONS. Just explain how - will you??? Just so we all understand
@californiadreaming92164 ай бұрын
@@CosmicSeeker69 hey Einstein: please jog my memory...when and where did I state that residual dirt/rust is the only source of carburetor contamination?