HK prostreet ute, using the shrinking disc to pull up the lows from a previous repair

repairing a previously damaged panel with the shrinking disc and bit a slapper and dollying.
I haven't gone too full on as we still have a lot of metal fabrication work to do inside and can risk damage to panels.. but hope the video gives you an idea of this method...

[@LynneHancox]

Looking good

[@andrewwhiting5526]

What speed did you run the shrinking disc at? Great work you made it look so easy

[@lmhmetalworks7448]

Not sure on its actual RPM but i run it in the low switch speed on a polishing 9" grinder..

[@user-cj7mw7is8e]

Рекомендуем скорость 6 тыс. оборотов.

[@deankavanagh9832]

Thanks for posting this. Looks great! What was the blue stuff you wiped on ? Is it a guide coat or lubricant?

[@lmhmetalworks7448]

Hi sorry for the late reply.. its makers dye, whuch i use it to find highs and lows..

[@chakkram2012]

Good job but use hearprotection

[@paulj8283]

Looking good! Are you going to fill the tarp-hook holes?

[@lmhmetalworks7448]

Thankyou 🙏. Definitely, will weld and smooth out everything. Not 100% sure about a lid yet tho. 🤔