HK21- demil the front shroud and remove the trunnion

[@steelwolf411]

Looking forward to the rest of the build. May have picked up a few kits myself

[@baydog308]

Great call on the bending jig bar. I completely forgot about that and was a perfect fit. 22mm diameter. No additional cutting need on mine and popped the trunnion right out. The force was enough to shear the little bit of sheet metal on the old receiver that was welded near the cocking tube.

[@UFPTX]

This was the case on the second kit I have. I cleaned up the cocking tube piece and pushed it right out.

[@thomasforman7628]

Mine is almost done. This week, my buddy ken at kc arms in Texas. Is building it. I will run it with my sear pack cant wait. Good luck to yours there. Thomas