The Charlie Show /// Episode 349 /// Series Plug Install and Soldering pointers.

When it comes to big power setups, often soldering on good quality plugs is necessary. With big wires and big plugs, things can get tricky. These topics should help you install your plugs correctly and perhaps address some simple trouble shooting as well.
Email Us anytime for assistance - [e-mail]
Win a FREE Hobbywing setup. Check out our Podcast - anchor.fm/hobbywing
More Soldering Videos!
• The Charlie Show /// E...
• The Charlie Show /// E...
• The Charlie Show /// E...
• The Charlie Show /// E...
• The Charlie Show /// E...
• The Charlie Show /// E...
• The Charlie Show /// E...
HOBBYWING Official KZbin
+++++ Cars & Trucks +++++
Xerun series (Professional grade)
Ezrun series (RTR / MAX upgrade)
QuicRun (starters)
+++++ Helicopters & Airplanes +++++
Platinum Series
Flyfun Series
Skywalker Series
+++++ DRONE +++++
XRotor Pro Series (Pro.Filming /industrial, Gov. research)
XRotor FPV "M" Series (FPV Racing)
XRotor Series
+++++ Marine +++++
SEAKING Pro Series (Speed racing)
SEAKING Series (Marine)
Our mission: Help create memorable moments worldwide.
HOBBYWING Factory: www.Hobbywing.com
HOBBYWING North America: www.HobbywingDirect.com
Hobbywing
Twitter.com/Hobbywing_
Copyright & Trademark
HOBBYWING is a registered trademark of Hobbywing technology.
#HOBBYWING #NerdTheNewCool #HDUB

[@Trabevion]

What perfect timing i shall serial solder my new ESC 🙂

[@ImAcoastpedder]

About to do my brand new Max5 & 5690 I just got from you guys. Thanks a bunch 👍🏻👍🏻

[@MadDonJuan]

You can thin the conector lightly using a bit of flux and get better results results

[@DanPRC]

I use that second method as far as placing the wire in the bullet before the solder but I put some flux in the bullet first. Makes it go much smoother. I use that same exact solder and their brand flux. I also use a Dremel torch now. I’m never going back to electric. Your iron might not be getting as hot as it says it is after time.

[@redndeyes]

Flux is a game changer

[@allphungandgames4179]

I received a EZRUN Max6 setup for a single battery but I typically run two batteries. Is it safe to run a small extension that allows two batteries to be hooked up?

[@eddiefortmann02]

i bought a max6 g2 esc for my Xmaxx. is that the correct one i should have gotten?

[@maltesrc]

That aaaaaaahh😂

[@OH-Hobbies]

Hey do you know if the first generation fusion 1200kv motor has some type of fail safe feature, in case lets say, one of my wheels gets stuck crawling, and it starts to bind up, and I do not release the throttle. The motor shut off, until I released the throttle, then turned back on when applying throttle. I just noticed this. I know I’m not supposed to try and get one of my tires stuck, where the truck is binding up, but after testing it again by grabbing the wheel with my hand to try and get the motor to shut off, (until I release the throttle), it did it again. I never noticed it before, when I used to run that truck (axial bomber), and was just wondering if that is some type of fail safe, so you don’t burn up the motor???

[@G1ZQCArtwork]

Grrrr. It is NOT Soddering, it is SoLdering..... 🥺🧐

[@joshuajkoplin]

We all say soddering. Get over it dork.