Holley Sniper EFI | Distributor, Coil, CD Box and Throttle Body! | GBody

[@jesusvilla7894]

Glad I came across your channel I’m doing the same thing to my SS only mines going to be boosted but your videos give me ideas on where and how to route everything. Thanks man 👍

[@DarkZeroMotors]

Appreciate you coming by. If you have ideas as well let me know because this is a first time install. Trying to plan it is the key

[@theunderdawg]

Do you have the part number for that upper rad hose I need one to connect straight like yours instead of to the side like stock it’s hittin my temp sensor

[@DarkZeroMotors]

If I remember right that’s an Autozone hose. I ripped the tag off a while back but Part number will either be E71558 or E71028

[@theunderdawg]

@@DarkZeroMotors ok I’ll check it out and see thanks for the reply

[@DarkZeroMotors]

Absolutely!

[@sixgod1316]

Looks Like 500 Horses To Me 🏎💨💨💨🏁🏆💯

[@fastjp72]

Some people have had problems running Sniper EFI on a dual plane intake and some don't but if you have any weird issues then put a open spacer with no divider in it on intake under Sniper EFI so it can cross read correctly from both sides of the dual plane intake. If you watch Engine Masters on Motortrend you will see that they had problems with Sniper EFI on dual plane intake and had to modify it to make it work correctly.

[@DarkZeroMotors]

Thank you for the advice! How thick should the spacer be for it to read correct? I used to have one with my carburetor set up. I believe I’ve seen the episodes but don’t remember when they had the issues with the dual plane

[@fastjp72]

@@DarkZeroMotors 1/4" or thicker is sufficient enough. I have a 1/2" spacer on mine. Most common is 1" which would be good plus also gives you more air volume which is a bonus.

[@DarkZeroMotors]

@@fastjp72 sweet. My main concern is the whole thing not being able to clear with the hood. I’m sure it’s very close right now. Don’t really want to get a new hood for now

[@jashawnwesley9126]

i have same type of setup, cran hi 6 coil and box with mallory distributor, my thing is , are are able to control timing with this setup? im in the process of hooking my sniper up. im gonna run supercharger and id really like to control timing

[@DarkZeroMotors]

You’ll need to run the hyperspark distributor so the sniper controls the timing. Then you can adjust in the 3.5” screen or laptop