Holley Terminator X - Basic Sensor Scaling

Quick little video on how to setup scaling on linear sensors on Holley EFI. This will work on all Holley EFI platforms. In this example we use LowDoller-Motorsports MAP and Pressure Transducers.
LowDoller-Motorsports:
lowdoller-moto...
M.F. Kustoms
www.mfkustoms.com

[@robostyle9773]

Thanks so much for the helpful video!

[@ogsuperflygarage]

Great video! Truly helpful...

[@mfkustoms]

Thank you!

[@ahlers1977]

Im on the v3 software & cannot get the kpa to -14.5 for my Low Dollar 3 bar.

[@mfkustoms]

Most likely you have your default view in KPA. You would start at 0 and go to 300. -14.5 would be PSIG. If the scaling on the graph says KPA then you will start at 0. Low Dollar supplies both scaling.

[@ahlers1977]

​@mfkustoms thank you that helped me out tremendously!

[@svegt]

When making the changes and scaling the low dollar sensor should lap top be connected to terminator x or save it to sd then upload globe file?

[@mfkustoms]

You can do it either way. I prefer to use the laptop connected to the ECU, but you could do it via the SD Card.

[@timweb1510]

What products do you sell that I could use for my 351w turbo setup? I have the Holley hp, dual sync, Holley digital dash, etc

[@mfkustoms]

You could use our adapter but might make sense to use Holleys wiring since you will be running their distributor and dash.

[@jpcustoms4617]

I did these same steps on my low dollar 100 psi sensors for fuel and oil and they both read 0 psi… the previous issues was Amazon cheapies they would read but were a lot lower than what the mechanical gauge said it was at, any ideas on what to try to fix it? Both are plugged into the factory terminator x harness for fuel and oil, thanks.

[@mfkustoms]

Go to our website and contact us. We can help troubleshoot.

[@tylerbagby3619]

Having same issue. Do you remember what you found?