Getting ready to marry up my cryo treated Tremec Magnum to the 623hp 392 Hemi that I won from Holley. This is great information to make sure I don't mess anything up on my project. Keep up the good work guys!!
@f1hotrod527 Жыл бұрын
Holley really does a good job with these how to videos. This host is also very good.
@monster22692 жыл бұрын
Jeremy, great info. At 64, been doing this a long time. I truly can say I learn something new everyday. Thank you Sir. Great job Holley!
@g3garage2 жыл бұрын
Great video. Very helpful in understanding the importance of aligning the bell housing.
@robertlambert52992 жыл бұрын
Ol Cleet was banging those gears!
@michaelgrogan32249 ай бұрын
Superb explanation!
@PANTYEATR12 жыл бұрын
This was the best explaination I've watched yet. Good job Holley💪
@robertclymer69482 жыл бұрын
Thanks for sharing! Had no idea this was critical. Makes perfect sense though. Well done sir. Blessings from Motown.
@marktiltins88452 жыл бұрын
Yes that was good info doing auto to manual conversation soon with T56F , thankyou 🎯🤙
@WilliamJenkins-tx5jr5 ай бұрын
But with offset dowl pins, how does the bolts for the bellhousing line up?
@MethuselahMusic2 жыл бұрын
Now lets see you do it on a small block Ford, with a bellhousing opening 1/3 that size. Nightmare... cut down my dial indicator and my measurements are still all over the place! Basically stuck mounting the magnets on top of the bolts, which obviously doesn't work. Oh ...and I have XXL hands, which adds to the fun.
@mikeskidmore675418 күн бұрын
GEt some longer crank shaft bolts and bolt a plate over the flywheel and mount the magnet on the flywheel .
@DocHorn-r7s Жыл бұрын
Great Info !
@BigPermGarage2 жыл бұрын
Good explanation, thanks. Wondering if highest point is prefered more than the 12 o'clock position though?
@vrm86gt2 жыл бұрын
good info
@ZEPRATGERNODT2 жыл бұрын
Agreed
@mikeskidmore675418 күн бұрын
Just looking at videos like this, makes me think that it would be hard to center the magnetic base.
@Archangel3083Күн бұрын
Mine never goes into the positive does that matter?
@ryanwallace61722 жыл бұрын
Will this still work even if there is a large notch where the clutch fork goes?
@johnbridges50732 жыл бұрын
can someone tell me where i can get a drawing/ diagram for the mount bolts to motor for 2003 dodge 1500 4.7
@alberthodge631 Жыл бұрын
👍
@abefromen3 ай бұрын
what if I don't have any friends to rotate the engine so I can watch the indicator?
@FL4TFOUR3 ай бұрын
Set your phone up to record a video while you’re turning it
@maggs131 Жыл бұрын
Nice maeshering 🤭
@matthewstorm51885 ай бұрын
Is this really THAT important considering that the OEMs don’t do this and that NOBODY bothers to align the transmission to the bellhousing?
@davecolquhoun93152 жыл бұрын
And do not use a tap to chase the threads, use the proper tool