Holts Radweld Leak Repair Instructions

Find out how Holts Radweld repairs leaks in your car's radiator. www.holtsauto.com/holts/produ...

[@latitia3390]

This product WORKS. Had a leak in my system and one treatment of this fixed it. I’m talking it would leak a full reservoir full of water on a short 25 minute drive. No leaks at all after one treatment. Brilliant stuff 👍

[@jawadahmed7220]

i have a coolant leak in my car so do you pour the entire bottle in there?

[@latitia3390]

@@jawadahmed7220 I believe I poured around half a bottle into the water reservoir and it worked just fine. May need to adjust the amount if you have a bigger reservoir. I have a Vauxhall Astra 2008. I’d say my reservoir is about average size so if your car is smaller or bigger use a bit more or a bit less than half. Hope this helps!

[@jawadahmed7220]

@@latitia3390 okay i will try it out thank you 😊

[@wmsstuff271]

Yeah but it's temporary. You always have to worry about the leak opening again and you not noticing until smoke starts belching out of your engine. Especially if like me, your car has no visible temp gauge.

[@latitia3390]

@@wmsstuff271 I know, it did it’s job until I was able to get to the mechanic though who sorted it.

[@Outback_Recluse]

I've just bought a car with chemweld in the radiatior and heater system. It is holding water well, I didn't know about this repair until last week, when my mechanic serviced my car. I live in the South Australian outback and have driven it long distance and in hot conditions, it's just fine. I've had the cabin filters replaced with the service. With the a/c running it's fine but with three heater running it has a obnoxious odour, is this from the chemweld in your experience?

[@wheelieschulz1204]

I found it on a gas station when I needed an emergency fix I give it a try it worked it even holds the 105*C coolant temp the bmw engines get up to when at low load, so now I can use the car until the new radiator has arrived.

[@moshazza5684]

What are the chances of this clogging the channel's in radiator?

[@TheArSeNaL3000]

I’m getting some for my car but this video isn’t helpful... do we pour it in and fill to the up with the current coolant in there or no?

[@claudioformosa8163]

he said it at the begining of the video, yes you do

[@pepitreu755]

Hola para junta de culata calenton al bloque motor pequeña fisura el agua tiene burbujeo aire

[@astongrad930]

Do we pour this into the same place as where we put the coolant? I have a coolant leak in my bmw. Also, I also have an oil leak, do I pour this in the same place that I would ordinarily oil?

[@HoltsAuto]

Hey there. Radweld is poured into the coolant reservoir, and designed for coolant leaks only. It will not repair oil leaks from engine and should not be added to engine oil, as this can do damage.

[@astongrad930]

@@HoltsAuto thanks for getting back. I discovered this item when the leak got worse, if I knew of this way back when it first started I reckon it would have done the trick

[@auroraborealis9712]

Should I drain 250ml from the coolant then I add 250ml of holts or no need to do that?

[@VickiAnselm-mp9np]

Spark plugs lol

[@VickiAnselm-mp9np]

Don’t go by the advert I looked on the instructions and it said not to mix with coolant or anti freeze and suggested also removing shark plugs sounds more complicated than this nice advert

[@Cumdown]

You are looking at something different then. I've the bottle in my hand and the instructions confirm the information in this video

[@paulcosadinos1324]

This isn't an instruction. It's an advert.

[@daniela1797]

Worked perfectly on my bmw

[@HoltsAuto]

Glad to hear it Daniel!

[@derektierney1314]

Hey Daniel how long did this work for in your BMW ?

[@daniela1797]

@@derektierney1314 Hi Derek, still going strong haha almost a year!

[@derektierney1314]

@@daniela1797 Tks for that, & for getting back 2me so soon 👍

[@micky229]

Did you just poor in into the reservoir?

[@Zobablob]

these aren't instructions...

[@jamalelyyan7432]

Hi You know how to use

[@Blinkydabill]

@@jamalelyyan7432 will this work for a leaky water pump seal

[@silviuchitic162]

@@Blinkydabill I just bought a bottle and going to try tomorrow. Had a leaky water pump that leaked from the bearing, now the new one leaks from the seal for some reason. It's a small leak, every week or two I have to add ~250ml and car is 15 years old. Can't see the leak happen but I see pink traces of antifreeze around the seal.

[@citizendc9]

@@silviuchitic162 Did you have any success?

[@silviuchitic162]

@@citizendc9 Hello, yes it works but I don't know if it will be a permanent fix. I used it on the 6th of April so a month ago. The first 3 weeks it didn't drop but last week I noticed it had dropped a bit again, went from 1/2 a reservoir to 1/3 or so, checked again today and it hasn't dropped any further. I used to end up with an empty reservoir every 1-2 weeks. I can see white stuff around where the antifreeze used to leak from and the area looks drier.