Home cinema Monitor Audio Silver 8 + Marantz SR6011 / MM7025

[@alfasl3681]

which speakers drives 7025? is it possible to setup it to drive fronts and all other 9 speaker to be driven by 6011?

[@djradman6794]

Nice system!! What movie is this?

[@zukaka84]

I have Silver 10 with 4 ohms impedance. I am not sure if this amp will perform well with those speakers.

[@MrStingPower]

Hi there monitor audio silver 8 or b&w cm8 which one u prefer?

[@thiagodelgado3128]

MM7025 can push to full load and reference levels this monitor audio?

[@srirampalamadai6793]

Can you share your Audyssey settings after you connected the SR to the MM? Thanks. I am planning on doing the same. I am using Def Tech 9060 speakers with CS 9060/Atmos A60 and SR 9060

[@keidyez]

Hei! My audio/audyssey settings: MultEQ XT32 - Reference, Dynamic EQ - Off, -Reference Level Offset - 0dB, Dynamic Volum - Off, Audyssey LFC - Off. Speakers Config. i set all speakers to small (fronts, surround, surr.back and crossovers to 80Hz so the subwoofer gets and handle all the bass (subwoofer mode LFE).

[@marko6394]

Are you not using a center channel? I'm about to connect an MM7025 to my SR5013 and will have the center and sub running off the SR5013 and L/R off the MM7025. I initially thought this was a screwy setup but apparently it is fine.