Homelite Super 2

Picked up this Super 2 from my local dealer at a good price considering the pristine condition!
Stay till the end of the video for commentary!
It dies sometimes in the middle of a cut and is difficult to get started again. Let sit for 5 minutes and it starts right up and will run for another 15.
Leave your comments below.
Thanks for watching!

[@LancerXythensD0ntW4tchThi5]

Got my first saw today, let's hope this homelite will hold it's own

[@cookiemonster3979]

Have two super 2's and one XL . One was. New old stock I found looks like it's never been used. 16" bar on it. Others have 14" bars. They run awesome

[@samdittmar5142]

Fuel lines and carb kit and it will run awesome. I love these things. So simple that hardly anything can go wrong

[@relyk90]

Yeah I'll shoot him an email asking if I could send it up to him. I'm in the US. He sure does know what he's doing. Thanks for watching! Have a good night and a pleasant tomorrow

[@allaboutgears98]

Thank you buddy loved the raw working video of the saw I wish there were more

[@gardenmaintenanceuk7636]

give it to Bucking billy ray to tune up.you see him tuning a lot of saws on his uploads .best wishes from the uk

[@cookiemonster3979]

They have a 31cc. The XL has a 29cc or 26cc I think

[@wyattarnold9868]

Nice saw

[@50CC346XP]

check the wires to the kill switch coming from the coil i have seen them rubbing on the cylinder & worn and touches the alum cyl and kills the saw

[@andrewhondo]

its the fuel lines maybe that need to be replaced or the carb needs cleaned one or 2 of the problems i think

[@lukebowlin382]

It's easy to hit the kill switch, it might be grounding out somewhere.

[@ousamaabdu794]

Good Video there my man Is that a 14in bar? Also how what is the largest diameter piece of wood this saw can cut though comfortably? I just saw one on Craigslist for $45, think I will purchase it

[@relyk90]

Ousama Abdu mine is in mint condition. Ask the seller if there are both high and low jet screws on the carburetor

[@relyk90]

Yes 14" bar. I would say a 12" diameter log this saw will handle. As long as your chain is sharp and it's tuned correctly. Mine really chews through wood even with the bar buried! I wouldn't put a longer than 14" bar on it however

[@melandaverywilliams3288]

Kyler MAN I have that same saw. But my saw doesn't run as clean as yours. I got mine from a co-worker he said if I got it running I could have it. Well it's running but I think maybe it needs rings or something else. Oil comes out of the exhaust when it's running so I'm thinking replacing the rings on it may do it good. But yeah the chain that's on it bogs it down bad. What size did you say that chain was a Sthil? Good video

[@ryanlarrabee79]

For your saw it's a duckbill valve in the oil tank