Thanks for the video, I have a new 2018 750x and have the black bars, but I cannot seem to fit the bars under the light, cannot get the nut between the two plates to bolt it down at the two points shown from underneath, any tips would be helpful.
@neiltroman6851 Жыл бұрын
I did not use the bolts supplied under the headlight. I found it impossible to fit. Cut some longer bolts down to make a stud. Put nuts into the frame first and screw the two studs into the two nuts. I used lock nuts. Nyloks. This then gives you two hanging studs two offer the frame up to. Then put on another lock nut to hold the frame inplace. Its fiddly to get a spanner inplace but easier than trying to locate the nuts bolts spanners and frame at the same time. Note. t=The studs can be longer than the original supplied bolts.
@luiscoelho35232 жыл бұрын
Since they are called "light bars" are they supposed to protect the bike a little bit? Or just a fragile light hanger? :)
@riderfiles86064 жыл бұрын
Thank you for posting. Did you notice any new vibration sounds after installing?
@p.santos66445 жыл бұрын
Nice video, thank you for sharing 👍👍👍
@yosuquintana65765 жыл бұрын
Good video, but i cannot fit the left side to screw, cause a part of the bar, crash to the top of engine.
@sunuk19153 жыл бұрын
Nice job 👏👏👏👏
@muratevdeyok5448 Жыл бұрын
how can I buy? where is it sold?
@acpgiga6 жыл бұрын
As crash bars, are they any good?
@Checkpat5 жыл бұрын
They seem to be so near the side of the NC750... think that the fall of the bike even during stop will brake the side of the bike