Honda Rancher TRX 350 TE Replacing The Starter By kvusmc Pt 1

[@peggidixon8428]

Replaced my 2004 Honda 350 Rancher starter today. Thanks to your video it was easy - well except for getting the darn starter itself off. But then you had trouble with that too so I don't feel too bad. Matter of fact I feel pretty darned good 'cause now I can ride my 4 wheeler again.

[@KVUSMC-KU4SMC]

Awesome Job Gal

[@drsuperhero]

Did anybody see the starter get replaced?

[@DannyV1973]

nope and that what i needed to see

[@drsuperhero]

Danny Vacon I realized there was a second segment. It was super hard to get the starter out!

[@DannyV1973]

@@drsuperhero i got to it just fine but it wont budge out,,pain in the but will try again today

[@drsuperhero]

Danny Vacon no kidding I needed a hammer and a crowbar. I hope it’s not that hard to get back in!

[@DannyV1973]

@@drsuperhero i soaked it good with rust check overnight ,this morning i got it to wiggle 1/4 inch finally with a prybar came off,,way easier going back in..hope next time i will be able to take it out easier ,even once a year just to loosen it.

[@Bey11ktb]

How did you diagnose this problem? When replacing the started what Else do you suggest?

[@KVUSMC-KU4SMC]

It has to me before Try pull cranking it allot of times starters will get a bad spot on them

[@jpsraugust9284]

Ok, here's a project for you to figure out because I don't understand this problem at all. I have a 05 trx350fm Honda Rancher 4x4. So here's the problem, the atv had been setting outside for at least 4 yrs. so I got it and cleaned it up and replace a lot of things on it, but when I rebuilt the starter and put it in the 4 wheeler, well when I try to crank it I can here the starter but it's not turning the motor over. So I took it back off and put my finger in the starter hole and could fell a gear. The gear will turn clock wise easily (clockwise looking at it from the back of the motor). So I took a digital caliper and mic the distance from the gear to where the starter would be if mounted, I also mic the length of the starter gear and the starter gear is plenty long enough to reach the gear inside of the motor. So I'm at a point to where I have no idea what to do. I would certainly appreciate any bodies help with this. Thanks.

[@kountryquads9475]

Sitdown BeQuiet send the starter back or buy a new one. That’s what I would do.

[@WORRO]

Geter done man!

[@KVUSMC-KU4SMC]

Thanks John

[@21sandwich3]

so sir I was wondering if u can tell me to how to put on my battery cover it's being a bitch I just got it rebilled

[@KVUSMC-KU4SMC]

I found it in my manual buddy

[@severly808]

That there's sniper dave!

[@KVUSMC-KU4SMC]

It sure is buddy