Thanks helped me because the enclosed instructions were like abstract paintings!
@tarynadams20562 жыл бұрын
*Works so well **Fastly.Cool** that it only requires daytime operation until high temp and humidity are overnight. It is difficult to get to side filters, but back is easily accessible.*
@nickymcneill2600 Жыл бұрын
Really helpful video. Purchased a Meaco air conditioner with very meagre instructions. Was totally baffled as to how to fit the flexible window kit until I found this video by accident. Thank you!!😀
@majidkashani4257 Жыл бұрын
Are you happy with Meaco air conditioner?
@MrChrisTew3 жыл бұрын
If anyone's having trouble. It fits a lot better if you do the blue line first then the red 2nd. I had a heck of a time making it fit until I reversed it
@mandomrix2 жыл бұрын
THIS GUY RIGHT HERE
@jpbcos2 жыл бұрын
Great tip! Thank you!
@noreenevers20272 жыл бұрын
Blue line is the 'curved line side' as shown in the instruction - which means it gets done first anyway.
@noreenevers20272 жыл бұрын
What doesn't make sense is that, logically, you can't access all of the red line area if the blue is done first.
@devileyeuk2 жыл бұрын
This was a great tip.
@thewoodedyard2 жыл бұрын
This was a huge help for a four sided install. Thanks so much!
@ZakSaaflondon3 жыл бұрын
16k views and only 1 comment so I will step up and say thanks for uploading this.
@MalO.ver1.0.x Жыл бұрын
Man thank you so much for uploading this video. I would have probably spend hours to set this up based on the little manual booklet alone. 😅
@Myrdraall6 ай бұрын
We just removed it an hour after installation. Terrible for rain. Tends to pool up top and run down inside by the zipper. I'm just glad it started raining in the evening and not at night while we were sleeping.
@mommarozzz65843 жыл бұрын
Okay but my window frame has a crank and a lever for a lock so where am I suppose to put the Velcro? Over those two??
@gdfgdfgfgdfgdfg2 жыл бұрын
Did you figure this out?
@xoxviolencexox76632 жыл бұрын
I put mine in the inside edge to avoid the crank and lock which are on the ledge. It's holding up nicely given its one a small track.
@jessicasager41392 жыл бұрын
I’m having the same issue, and ours our right against the “inside” of the frame. If I try to install it around them, vs in front of/above them, it would close them in the seal. Sigh. Nothing is ever as simple as it’s supposed to be, for me at least, lol.
@noreenevers20272 жыл бұрын
You can put them inside or outside - wherever the velcro best fits ( you just might need to open the zipper to access them)
@mommarozzz65842 жыл бұрын
@@gdfgdfgfgdfgdfg nope I returned it. It was junk. I bought myself poster board, lined my screen window and made a hole for the exhaust vent. Cost me $2. Easier then this crap.
@johnb2751 Жыл бұрын
Thanks you for your video this is exactly the same window as mine. So helped me out loads.👍🏻👍🏻👍🏻👍🏻👍🏻👍🏻👍🏻👍🏻
@kinesis48682 жыл бұрын
Is the sticky tape Velcro easily removed without marking and can it be reused or do u need to buy replacement each time you take down/put back up? Thanks
@bartgroeneboom34342 жыл бұрын
It can be removed with some glue remover. Can't be used again unfortunately
@king0vdarkness2 жыл бұрын
what if it opens upwards instead of sideways and is a really wide window?
@josephomoyajowo8509 Жыл бұрын
That's what I'd like to know too. My windows is exactly what you just described
@MikaTarkela2 жыл бұрын
I don't have a casement outside the window frame or is the 2nd velcro supposed to be "inside" the window?
@bartgroeneboom34342 жыл бұрын
You could attach it somewhere around the window for installation
@aidankhan61943 жыл бұрын
Excellent video. Thank you.
@reeeeee43022 жыл бұрын
The zippers seem to be on the wrong side
@KovalGrey2 жыл бұрын
I had that too. Not sure if it was because my window opens from the right and not as shown in the video? Still did the job though, just 😅
@SaleN952 жыл бұрын
I have the bottom of the window about 1 meter high (I live in an attic apartment) and so the pipe keeps pulling off the zipper or sometimes the pipe just slips out of it no matter what I do. My window is not rectangular or square because it follows the plane of the roof at the top of the window and the window is bigger than the average windows, so the net is just tricky for it. But what else can I do?
@noreenevers20272 жыл бұрын
I taped mine to a 45* 6" stovepipe - bending it to the best angle and thats what mostly hangs out the window - stays out just fine. (I also tied the zippers around it together with long zip ties so it can't fall out (or in)).
@IceManLikeGervin2 жыл бұрын
Thank you...
@NeykaBlitZ3 ай бұрын
The instructions are wrong , reverse the curved side with the straight side else zipper will be wrong side
@iri62053 жыл бұрын
Thanks But what a mess it looks awful Think I will cut a vent in the wall
@trevord7659 Жыл бұрын
Do you mind sharing a picture of the vent you installed in the wall? Thanks