How do you design whole home power backup using software?

Рет қаралды 559

Ай бұрын

ElectricalOM can help design your entire home or work place electrical system including a gateway and backup facility. Combined with solar PV!
This is a whole other level to any other software on the market.
I run through my approach in setting this out after a few other contractors asked how I do it.
Free 14 day trial is essential if you have not tried this yet
electricalom.com/site/free.php
Thanks to all the new subscribers. Humbled to have made it to 12k subscribers!

Пікірлер: 8

@piney6587 Ай бұрын

Great software 12 months in of industrial designs and still keep finding new features that save you hours of work than using separate programs. The schematic shown in the video can be framed and turned into a cad drawing in less than a minute and if you spend the time to label can form part of your documentation pack for points of isolation etc for your renewable compliance. Pretty sure my face is on their canteen dart board, for the amount of time I email them or the long list of requests I send in 😂 which to be fair they do listen and implement. A work around for a stand alone main switch/switch fuse is to use the junction box option and add cpd, this will also allow you to change cable size at this point you can then change symbol to look like main switch. Junction boxes will show on the ukforms as a separate test Although you can combine them via circuit edit and notes tab.

@Buy_YT_Views.608 Ай бұрын

is beautiful KZbinr❤

@glynjones8187 Ай бұрын

Looks like an awesome piece of kit definitely going to have to look into it for training and course delivery for the new apprentices.

@electrician247 Ай бұрын

They do free licences for training providers if that is of interest. Thanks

@neilbridgeman7768 22 күн бұрын

I am just thinking that it may work better to not set the AIO as a UPS on a final circuit but set it up as an alternative ’source’. This way you can change the active source to ensure the installation complies in both grid tied and non-grid tied modes. I think you would do this by right clicking on the GW and choosing ‘add source’. Then change source type to DC battery.

@electrician247 22 күн бұрын

That is an excellent shout. Will give that a try!