How I put s550 Seats in my New Edge Mustang

[@jasondayton1581]

Excellent video. Lot of work, but the end result seems worth it. I have S197 seats in my SN95 and have been thinking about S550 seats.

[@MoneyisanIllusion]

I’m worried about the suede holding up. If I did it again I would go full leather.

[@jasondayton1581]

@@MoneyisanIllusion I think full leather is a solid plan. I see plenty of leather S550 seats available in my area and have been wanting something different. Not to mention, your video shows how to make the seats sit low...which I strongly prefer.

[@rescuemepookie5256]

thats bitchin..you did great. now im confident to try try this

[@MoneyisanIllusion]

Thanks. The trick is you take them all apart and leave the pieces in your garage for months. Then you feel bad and are forced to do it 🤣

[@andrei1971]

Do they recline all the way back?

[@MoneyisanIllusion]

They would recline just as they would stock. I just have them so far back that it hits the speakers in the rear behind the door.

[@Turbosquatch303]

Would you want to build a set of bracket for me lol

[@MoneyisanIllusion]

I was wondering how long it would be before someone asked. I think it would cost too much because of how much time to take apart the seat and make them. I also would have to take apart my seats to do it if I had to ship them, which is not ideal. If it was whatever you pay for the angle iron and $20 roughly for a junkyard slider you could do it yourself for under $200 but honestly it’s so much work I don’t think I would want to do it again even for $1000 because it takes forever. I did it little by little over about 3 months for both seats. To do it straight through would probably take a week. Are you near southern New Jersey?

[@Turbosquatch303]

I am in what some call south new jersey lol ie florida I have seats and sliders I would just need the angle iron drilled and the slots made in it lol but I'll try next weekend with a buddy who is a tech at Ford showed him your video he said we could probably do it in a day per side What thickness angle iron did you use

[@MoneyisanIllusion]

1/4” there’s a link in the description of which I used.