How I stack firewood

[@camcuts7643]

Great idea man!

[@deanfinnigan5577]

I put concrete mesh on the blocks. Works well.

[@thomasschafer7268]

Very good idea.most important is the air und the firewood for drying!👍👍🇩🇪

[@MrRickvs]

I still use this method for the past couple years even though loosing approx. 15% of the area of a cord due to the 4x4s now being shorter than 48" due to sitting in the cinder blocks by 8" I try to stack higher in the middle and taper to the outside edges to help with water runoff

[@wadimUA]

This is so simple, yet so effective! Will build it your way as a temporary solution (which might become a rather permanent one 😅).

[@johann-ulrichhofstetter2978]

Simple and good. Thank you!

[@MrWookie21]

You can also stack wood just between 2 trees and place pallets elevated from the ground with stones or smaller concrete blocks. Looks nicer...

[@AnonymousGameWarden]

That's a quick way to rot the trees

[@MrWookie21]

@@AnonymousGameWarden How quick?

[@AnonymousGameWarden]

@@MrWookie21 easily could rot and destroy both trees over than span of 5 or 6 years

[@MrWookie21]

​@@AnonymousGameWarden The stacked firewood would dry, but the trees would rot?

[@UnlimitedxxGaming]

Nice idea :)

[@paulosghost]

And the rain? You can cover on top but and on the sides?

[@shanepitzer4323]

You don’t cover the sides. Wood needs to breath.

[@paulosghost]

@@shanepitzer4323 yes, but the rain will hit the sides and get wet again

[@michaelgusovsky]

4 posts and a tarp. tarp can extend a few feet past the wood... the windier it is where you are, the more extra feet you need of tarp.

[@colecat11]

The wood pile is not 4’ tall. It’s 3’ 2 1/2” from the 2x4’s.