How I Tie a Ringbolt Lashing

[@yoopermann7942]

except for the plaiting, that`s the same knot i use to sew my clothes back together after a day of harvesting "WILD" black berrys thank you for the tips and ideas, hopefully there will be more in the future

[@CampbellCarving]

Thanks that, blackberries are yum. Ill have to try it in the future on my clothes.

[@96708kanaka]

I like to use a small blunted sewing needle for through hole work, it makeʻs it faster and more accurate. Awesome work as always.

[@CampbellCarving]

Awesome idea I'll give that a go.

[@StiaanyBoy]

Thank you for the great videos as always! I hope to see more in the near future :) stay safe and healthy during this difficult time

[@maheshprabhu1557]

🙏 namaste sir, Receive Greetings from India 🇮🇳💐. Lovely informative video and great guidance to us . I am Mahesh and I am from Mumbai INDIA. I am self taught wood carving artist. At present I do working on Maori culture hook pendants. And I want to learn threading,lashing,but it's very much hard to me to understand. So I watch your video...few steps I understand,but i am into learning process 😀. Some time lil confused too,how to go, Your video got me knowledge. 🙏 Best wishes to you and your family. Regards, Mahesh Mumbai

[@CampbellCarving]

Thanks for your support

[@DieselMerlot]

Awesome, nga mihi brother!

[@itsandbits1]

Thanks for another nice video.

[@CampbellCarving]

Welcome

[@iantapuke374]

Tena koe e hoa. What drill bits burrs sizes etc do you use to drill those ringbolt holes? Is it one of those flame type burr? Is it better to drill from both sides and meet in the middle? What size braid were you using for above lashing? Been enjoying your videos especially the lashings mauriora

[@CampbellCarving]

I use a 1.5mm sphere burr for the pilot hole then a 2LR 2mm burr to widen it. Sometime use a flame or triangle to smooth the edges of the holes. I don't worry about going from both sides. I used 1mm waxed polyester. Kia kaha e hoa

[@mermaida100]

Greetings; appreciate your videos...with this one I'm struggling to see all the cord action through your right hand at the beginning 😉 any help appreciated

[@CampbellCarving]

Sorry about that, perhaps send me a message on my site and I can help. Campbellcarving.co.nz

[@mermaida100]

Grateful; will do.

[@pipperrytook2314]

Gorgeous ☺

[@thecarvingshed]

Hey Campbell nice job! Question on your vice - Did you add any padded jaws to it, or is that what it comes with? Cheers!

[@CampbellCarving]

This one came with rubber padding the Jaws which is great.

[@MrDBerg1]

What size of lashing do you use? Thanks!

[@CampbellCarving]

I use 1mm cord usually

[@mihiwhymark310]

What size drill bit should I use for the holes for this kind of lashing

[@CampbellCarving]

I use 1.5mm burr for these

[@bfk1970]

Where do you get your cord from?

[@CampbellCarving]

Caudwells in nz