How long does your airplane need to clear the trees? Stinson STOL

[@caseyhutson5392]

Great contribution to the Stinson community. It's good for newcomers to see solid info like this. Nice work!

[@GreatMichiganBushCo]

Thanks for the compliment! If new I'd take those distances as a best case situation. There was some wind helping and I've been working on techniques to make those distances for years. The video was mainly on how to figure out your own distances. The 800' to 75' is definitely a "best case" scenario.

[@coppi60]

Nice video!!! Please consider more of these:) I hope you are enjoying being back in the air.

[@GreatMichiganBushCo]

It's awesome to be back in air! The next one will be on how to land short properly. Thanks for watching the videos

[@factbaba9593]

I'm also very passionate about planes 😀

[@GreatMichiganBushCo]

you can reach me at [e-mail]

[@flyingeden]

The Stinson and Franklin never disappoint 🫶

[@GreatMichiganBushCo]

Ha! Watch the engine out video, she's disappointed me in the past. Nothing quite like the sound though.

[@ClearedAsFiled]

Scooter, I have been watching all your videos and travels and I think you are a great (stick) tail wheel pilot....perhaps in a future video, you could share your experience getting a tail wheel endorsement and some of the practical lessons you have learned over time. Using a sight picture versus relying on instruments. ...2 wheel vs 3 wheel landings....refining stick and rudder skills doing dutch rolls....dealing with yaw...etc. Thanks again for all the great videos.

[@GreatMichiganBushCo]

Thanks for watching and great ideas! Dutch rolls 🤢🤮 I still get sick when teaching those things, no one is coordinated

[@Bearhawk_Life]

Great Video

[@GreatMichiganBushCo]

Thanks!

[@blainemacdonald6929]

I like long runways! But don't use much of them with my 230hp stinson but I'd rather have too much than not enough

[@GreatMichiganBushCo]

As you can see I use 250 ft with my Frankie 165 engine!

[@scottlittfin5832]

This Stinson has vortex generators, so it may perform better than a stock Stinson?

[@GreatMichiganBushCo]

It performs noticeably better than it did before input the VG's on. Check out the video. I did performance checks before and after.

[@brianmoffet]

By the book includes how they measured the takeoff distance (reading from the Operating Manual): The quickest take-off is obtained when the flap control is place in the first notch. (item 36 page 26) But, Item 37 says: take off distances were conducted under the following conditions: Wing Flaps Up So, the operating manual leaves a hole about distances. I know I can take off in about 700 feet without trying when I use the take-off flaps setting. I fly a partially metalized 108-1 with a Franklin 165. It's a bit heavy. Other than that, given the lack of information in the manual, learning about the airplane you fly by experimentation is the best bet. Especially since these planes are very old and have had changes in rigging etc.

[@GreatMichiganBushCo]

Off the ground is quickest with the flaps, but the additional drag really causes loss in rate of climb making a no flap takeoff shorter to the 50'.

[@brianmoffet]

For those paying attention, I run a 7654 prop, which is a cruise prop. 7652 is a climb prop for this aircraft/engine combo and would get a better climb.

[@michaeltrboyevich7854]

One question my friend . .....Do you always " zero " your trim tabs for a launch ?????

[@michaeltrboyevich7854]

Especially with any 6 cylinder engine over 200 horsepower ... I myself , being instructed by my father , a WW2 Army Corps Flight Instructor , and like old Bob Hoover .. never used trim tabs .......Spoiled fellow pilots .....

[@GreatMichiganBushCo]

Absolutely. I set the trim for takeoff. An out of trim plane can be a handful and has killed many pilots.

[@Nwwind22]

Going to try it in the mooney :0

[@GreatMichiganBushCo]

It would be good to know if you're flying in the hills at night.

[@ionhunter]

A VERY empty B-17 once took off from Dalton Airport (3DA)

[@GreatMichiganBushCo]

That would have been a site to behold. I bet the tree is off the end. Were a little shorter back then

[@danielandvictoriasmith936]

I am building a 425hp experimental that will be a 4 door 6-seat 108 with wings lengthened 2 ribs in the slot area for approximately 41 foot wingspan, slots extended 2 ribs towards the fuselage, wider aileron’s to match, bigger rudder, micro vortex generators and extended flap hinges with custom pockets where the flaps go up.

[@GreatMichiganBushCo]

That sounds like a beast. I with this plane had more flaps.