How Runout Is Measured Using a Dial Indicator

[@izetassky]

so what is the result runout in this video measured by the gauge?

[@cooldude91062]

How is total runout measured?

[@radhasyammuni3003]

With this animation how to align the shaft to make run-out problem to 0.010

[@Gdandtbasics]

The large diameter, which is assumed to be the Primary Datum Feature, has to be running true. The only way now to get this part running within .010” of the Primary Datum Feature is to recut the small diameter. If it was desired to get the smaller diameter running within .010”, regardless of the larger diameter, then the larger diameter would have to be shimmed so that it was no longer running true. This would push the larger diameter out, but bring the smaller diameter in. We hope this helps!

[@srinivasanvivekanandhan8366]

​@@Gdandtbasics😮😮?

[@srinivasanvivekanandhan8366]

?😢

[@srinivasanvivekanandhan8366]

😢😮I😮i😢ஈ i😮😢ii😮you