How to bag your LS 400

For this installation, we are using the airlift Performance complete front and rear suspension, paired up with the airlift 3P management system with single Viar 444c air compressor. This is also dialed in with 3/8” airlines.
We go over the step-by-step directions for the removal of the OEM suspension and installation for a complete air ride set up. All tool sizes are provided within the video during the steps of install.

[@BrandonJagger]

i plan on getting an LS i already have a gs and watching this video was perfect to know what i need to do...thank you!!! keep up the good work

[@nathanz6230]

Seriously good video super informative

[@thatsteez_]

Thank you very much!!! I hope to provide the most information I can to help out with these installs!

[@jameslum1902]

Could you do a short showing how specifically you ran the lines under the car?

[@nemesis3884]

Where did you buy these wheels?

[@zach7658]

they are leon hardiritt orden you can still buy them new, or find a used set

[@jamieberry1813]

Dope

[@thatsteez_]

Thank you!!!

[@hiroshi138]

Cool video. Two questions... how do you set the preload, and can you drive the car with it aired out?

[@thatsteez_]

With this install, everything was checked to ensure that the components on the struts were tightened, But nothing was adjusted for preload. The damping settings were set to what is recommended by the user guide book for this platform, which is available with the Airlift kit for the front and rear. if needed, I can provide that information for this platform on the front and rear damping recommended settings. This specific vehicle cannot be driven while aired out as the undercarriage sits on the ground. There may be some vehicles on air suspension that may be able to do so, but all cars will vary.

[@hamishcoombe7331]

@@thatsteez_ well you can ride aired out if youre fine with scraping

[@mid7299]

🙏🙏🙏

[@thatsteez_]

Thank you!!!!

[@jamaldiamond4166]

What size are the wheels

[@thatsteez_]

I believe these may be 19”. Not sure of the specs on widths and offsets unfortunately