Wow, this has been massively useful in getting this configured. Lots of little undocumented "this and thats" to get the Turnigy 9 configured with PixHawk. Everything is hooked up...still haven't programmed my ESCs, (Emax Simon 12A) and still have gotten no response from my motors to transmitter commands even though red LED in receiver is steady and not blinking.
@pghsteel369 жыл бұрын
I've been following your build and doing this on mine. Up to this point, everything was fine. My esc's just beeps. I've programmed just like your instructions but to no avail. Did you have the qbrain plugged into the Pixhawk RC spot, while programming or was it unplugged? And are all the wires on the signal side of the hub? Your detail picture shows them not in line but you say they should. Now my esc's just beep and believe it cannot be reversed.
@TintTechs29 жыл бұрын
do you have any trouble at all ru,ning the Qbrain ESC with the Pixhawk? i have the Emax and realize now that it is not compatible with Pixhawk. i'm looking to buy another 4 in 1 but unsure of which one to buy.
@353flyer7 жыл бұрын
Hi mate, is it really necessary to get the programming card?
@selfstudy19294 жыл бұрын
Is it necessary to do
@Learnrobotix-learnrobotics9 жыл бұрын
Offroad Footage, Here is the link to the webpage for the associated footage. Sorry that I couldn't reply directly on your comment, for some reason I don't have the option because it is linked. (?) learnrobotix.com/uavs/quadcopter-build/pixhawk/calibrate-q-brain-esc.html